View source for FMC640 CAN \ Tachograph

==CAN \ Tachograph==

'''CAN \ Tachograph''' are used to configure device when connection of CAN1 and CAN2 BUS lines are performed. <br>

Teltonika recommendations: <br>

* FMC640 CAN1 connected to vehicle's FMS(J1939) BUS line<br>
* FMC640 CAN2 connected to vehicle's Tachograph - Instructions can be found on [[FMC640 and Tachograph Solution]] wiki page;

==Tachograph Settings==
<br />
'''In FMC640 configurator “CAN/Tachograph” section tachograph settings should be set in order to download files.<br />'''
<br />
DDD download source – to which CAN line tachograph is connected;<br />
<br />
Tachograph ignition source – which DIN is connected to vehicle ignition ("Ignition" parameter - tachograph ignition source will be the same as configured in "System" -> "Ignition Source");<br />
<br />
Download alternative DDD card files - enables the possibility to download specific DDD driver and co-driver card data from non-original locations. It may include last download information;<br />
<br />
Alternative tacho settings – device will automatically change tachograph address, which can be useful, when additional devices are connected to the tachograph;<br />


[[image:FMB640_Tachograph_settings2.gif]]
<br />
FMC640 can be wired to Tachograph using instructions provided in [[FMC640 and Tachograph Solution]] wiki page.<br />
<br />
NOTE: Alternative DDD download '''WILL NOT''' work with GEN2 Tachographs (VDO 4.0 or Stoneridge SE5000 8.0)

By default, this parameter is DISABLED.

==WEB Tacho Settings==

'''WEB Tacho Settings''' are used to configure Tacho WEB server to which device periodically connects.

WEB Tacho Settings:<br />

'''Status''' - functionality enabling;<br />
'''Domain''' – server domain where files will be send;<br />
'''Port''' – server port where files will be send;<br />
'''Start delay''' – delay after turning on ignition to start procedure of file sending.<br />

[[image:FMB640_WEB_Tacho.gif]]

==FMS settings==

FMS settings is used to configure FMS source. <br><br>
If you have FMS wired to FMC640 CAN1, FMS source should be selected as CAN1.<br>
If you have FMS wired to FMC640 CAN2, FMS source should be selected as CAN2.

[[image:FMB640_FMS_settings.gif]]
[[Category:FMC640 Configuration]]