View source for Immobilizing and locking issues using CAN-Control with Immobilizer


==Issue after upgrading CAN-CONTROL to CAN-CONTROL with Immobilizer?==
Possible encounters after upgrading CAN bus adapter:
*Vehicle doors Lock/Unlock is not working;
*Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''".
If You encounter with any of these issues - follow solution steps below.
==Solution==
After installation is completed and CAN bus adapter program is set, please, follow these steps:
#You will need to do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times''', but now continue to Step 2;
#Send GPRS command - "  lvcansetprog 11120" (or any other). Program number must contain 5 digits.
#Send GPRS command - "  lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme.
#After receiving a response to a command, do the learning procedure in Step 1.
{|
|-
|[[File:Alert.png|left|link=]]||<b>'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]].After completed these steps, commands to open/close and to block/unblock engine can be performed. All SMS/GPRS responses should inform You that particular command has been completed successfully.</b>
|}
{|
|-
|[[File:Alert.png|left|link=]]||<b>'''Note''': if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step"). If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated. </b>
|}
[[Category: Frequently Asked Questions - FAQ]]