Changes

Line 33: Line 33:  
----
 
----
 
{{{model|FMB1YX}}} shares the same USB port for connecting LV-CAN200 or ALL-CAN300 adapter and configuring device with PC.
 
{{{model|FMB1YX}}} shares the same USB port for connecting LV-CAN200 or ALL-CAN300 adapter and configuring device with PC.
{{{model|FMB1YX}}} can be configured using “SCAN” function or “Offline Configuration” (Figure 58)
+
{{{model|FMB1YX}}} can be configured using “SCAN” function or “Offline Configuration”
SCAN function – is in use when {{{model|FMB1YX}}} is connected to CAN adapter (Figure 55), then wait 10s (Note, that car engine must be started), disconnect adapter from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device (Figure 55). It is very important not to disconnect {{{model|FMB1YX}}} from power source during this operation, because if {{{model|FMB1YX}}} is reconnected all received CAN bus data will be lost. {{{model|FMB1YX}}} remembers received data from LV-CAN200 or ALL-CAN300 and at the end of the procedure when “SCAN” button is pressed, user will see all CAN data which is sent by adapter. Enable CAN data which needs send to server and save configuration pressing “Save” button.<br/>
+
SCAN function – is in use when {{{model|FMB1YX}}} is connected to CAN adapter, then wait 10s (Note, that car engine must be started), disconnect adapter from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device. It is very important not to disconnect {{{model|FMB1YX}}} from power source during this operation, because if {{{model|FMB1YX}}} is reconnected all received CAN bus data will be lost. {{{model|FMB1YX}}} remembers received data from LV-CAN200 or ALL-CAN300 and at the end of the procedure when “SCAN” button is pressed, user will see all CAN data which is sent by adapter. Enable CAN data which needs send to server and save configuration pressing “Save” button.<br/>
 
To configure CAN data:<br/>
 
To configure CAN data:<br/>
 
1. In car, connect LV-CAN200 or ALL-CAN300 to CAN bus and to the {{{model|FMB1YX}}} device , wait 10 seconds. Note, that car engine must be started.<br/>
 
1. In car, connect LV-CAN200 or ALL-CAN300 to CAN bus and to the {{{model|FMB1YX}}} device , wait 10 seconds. Note, that car engine must be started.<br/>
 
2. Disconnect LV-CAN200 or ALL-CAN300 from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device. It is very important not to disconnect {{{model|FMB1YX}}} from power source, because then all CAN data will be lost.
 
2. Disconnect LV-CAN200 or ALL-CAN300 from {{{model|FMB1YX}}} , and connect PC USB cable to {{{model|FMB1YX}}} Device. It is very important not to disconnect {{{model|FMB1YX}}} from power source, because then all CAN data will be lost.
      
===Selecting LV-CAN200 and ALL-CAN300 program number manually===
 
===Selecting LV-CAN200 and ALL-CAN300 program number manually===