Changes

If ''Crash Detection'' is enabled, it monitors acceleration on each axis which helps to detect an accident. ''Threshold'' and ''Duration'' values are set depending on the impact that is required to be detected. {{{model|FMB1YX}}} can detect events ranging between a slight tapping on the device and a severe accident.<br/>

If ''Crash Detection'' is enabled, it monitors acceleration on each axis which helps to detect an accident. ''Threshold'' and ''Duration'' values are set depending on the impact that is required to be detected. {{{model|FMB1YX}}} can detect events ranging between a slight tapping on the device and a severe accident.<br/>

If ''Crash Trace'' is disabled a crash detection event will be generated (included into the sent record) only when crash is detected.<br/>

If ''Crash Trace'' is disabled only one eventual crash record will be generated when ''Duration (ms)'' and ''Threshold (mg)'' values is exceeded. <br/>

If ''Crash Trace'' is enabled, {{{model|FMB1YX}}} will collect crash trace data with frequency defined by ''Trace ODR (Hz)'' parameter. Acceleration, GNSS and IO data monitoring duration during the crash event is defined by these parameters: <br/>

If ''Crash Trace'' is enabled, {{{model|FMB1YX}}} will collect crash trace data with frequency defined by ''Trace ODR (Hz)'' parameter. Acceleration, GNSS and IO data monitoring duration during the crash event is defined by these parameters: <br/>

* ''IO duration (s)''. IO data duration can be set for up to 30 seconds before crash event and 30 seconds after. <br/>

* ''IO duration (s)''. IO data duration can be set for up to 30 seconds before crash event and 30 seconds after. <br/>

On Crash Event detection, records will be generated from the buffer, following these configurable conditions:<br/>

There are three configurable Crash trace modes:<br/>

'''Trace Full'''

'''Trace Full'''

* Data tracked: all GNSS and acceleration data <br/>

* Data tracked: all GNSS and acceleration data <br/>