Changes

Line 58: Line 58:  
* 11807 - current Odometer Value (km). Odometer data will be counted from provided value.
 
* 11807 - current Odometer Value (km). Odometer data will be counted from provided value.
   −
[[File:Screenshot 2021-03-07 162223.png|left|thumb|230x230px]]
+
 
 +
Ignition source will be used to determine ignition of vehicle.
 +
 
 +
Possible ignition sources:
 +
 
 +
* '''DIN 1''' (Digital Input 1) - if ''DIN1'' is 1 - ignition is ON; if ''DIN1'' value is 0 - ignition is OFF;
 +
* '''Power Voltage''' - if voltage is between High Voltage Lever and Low Voltage Level (below ''Ignition Settings'' options) - ignition is ON; if voltage is higher than High Voltage Lever or lower than Low Voltage Level - ignition is OFF.
 +
* '''Engine RPM''' - if ''RPM'' from OBD II or CAN is higher than 0 - ignition is ON; if ''RPM'' from OBD II or CAN is equal to 0 - ignition is OFF;
 +
* '''Accelerometer''' - if movement sensor detects movement - ignition is ON; if movement is not detected - ignition is OFF;
 +
 
 +
More than one ignition source can be selected at the same moment. When there are 2 or more sources selected, at least one condition has to be met to change Ignition status.
 +
 
 +
'''Example:''' DIN1 and Accelerometer are selected as the Ignition source. When the device detects movement, Ignition status will change to 1, regardless that DIN1 value is 0. Users can select movement start and movement stop delay time - those parameters are used when the accelerometer is selected as an ignition source. Ignition status is used in power management and the following functionalities: [[FMB001 Features settings#Eco.2FGreen%20Driving|Eco/Green Driving]], [[FMB001 Accelerometer Features settings#Excessive%20Idling|Excessive Idling]], Fuel Consumption, [[FMB001 Features settings#Over%20Speeding|Over Speeding]], [[FMB001 Accelerometer Features settings#Towing%20Detection|Towing Detection]] and [[FMB001 Trip/Odometer settings|Trip]].[[File:Screenshot 2021-03-07 162223.png|left|thumb|230x230px]]