Changes

[[Image:Fmb120_autogeofence.png|300px|right]]

[[Image:Fmb120_autogeofence.png|300px|right]]

AutoGeofence – the last known position after movement = off. If your car’s being taken away – you can be notified. The shape and size of the geofence zones are parameters. It is possibility to state whether entering in or out of the geofence triggers an asynchronous message.

AutoGeofence is based on the last known position after the movement has stopped. If your car is being taken away – you can be notified using this function. The shape and size of the geofence zones are set by parameters. It is possible to state whether entering in or out of the geofence triggers an asynchronous message.

AutoGeofencing option can be configured by following parameters visible in the right hand side figure.<br/>Activation Timeout (s) – when ignition is turned off and activation timeout passes, as AutoGeofence will be created around vehicle last position with set radius value.

AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure.<br/>Activation timeout defines the delay between when the ignition is turned off and the creation of AutoGeofence within set Radius value around vehicle's last position. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility.<br/>AutoGeofence can be deactivated by:

Radius (m) – radius of circle with center device coordinates after activating AutoGeofence feature.<br/>Deactivate By:

* Digital Input 1 – If DIN1 voltage becomes equal or higher than 6.9 V.

* Digital Input 1 – If DIN1 voltage becomes equal or higher than 6,9 V it will disable AutoGeofenze Zone.

* Digital Input 2 – If DIN2 voltage becomes equal or higher than 2.1 V.

* Digital Input 2 – If DIN2 voltage becomes equal or higher than 2,1 V it will disable AutoGeofenze Zone.

* Digital Input 3 – If DIN3 voltage becomes equal or higher than 3.5 V.

* Digital Input 3 – If DIN3 voltage becomes equal or higher than 3,5 V it will disable AutoGeofenze Zone.

* iButton – if authorized iButton is attached.

* iButton – if authorized iButton is attached.

* Power Voltage – if power voltage become higher that low voltage level (Ignition settings) it will disable AutoGeofenze Zone.

* Power Voltage – if power voltage becomes higher than low voltage level (defined in Ignition settings).

* Engine RPM – If engine RPM became higher that 0 it will disable AutoGeofence Zone.<br/>

* Engine RPM – If engine RPM value becomes higher than 0.<br/>

Feature – Priority of generated event, which will be applied to saved record.<br/>Enter Event – Event generation on Geofence entrance.<br/>Exit Event – Event generation on Geofence exit.<br/>On Both - Event generation on Geofence entrance or exit.<br/>Eventual Records – Enable or Disable Eventual Records functionality.<br/>Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility. If vehicle stopped and activation timeout has passed, an AutoGeofence will be created around vehicle’s last position with set Radius value.

Enter Event – Event generation on Geofence entrance.<br/>Exit Event – Event generation on Geofence exit.<br/>On Both - Event generation on Geofence entrance or exit.<br/>Eventual Records – Enable or Disable Eventual Records functionality.