Changes

Template:FMB I/O settings (view source)

Revision as of 13:05, 12 April 2018

43 bytes added , 13:05, 12 April 2018

m

→‎Avg Const

Line 38: Line 38:

==Avg Const==

−

If ~~avg const~~ value is 10, new value must be present for 1 second to register change to new value. ~~Internally~~ sampling is done every 40ms, so 25 samples are taken in second. To configure 5 seconds averaging multiply 10 by 5 yielding 50. The same logic works even if device is in ~~deep sleep~~ mode.<br/>Averaging follows RC exponential curves, see image below:

+

If ''Avg Const'' value is 10, new value must be present for 1 second to register the change to a new value. Internal sampling is done every 40ms, so 25 samples are taken per second. To configure 5 seconds of averaging multiply 10 by 5 yielding 50 as ''Avg Const'' value. The same logic works even if device is in Deep Sleep mode.<br/>Averaging follows RC exponential curves, see image below:

[[Image:Fmb120_avg_const.png|300px|center]]

−

For Boolean values 5τ, values is used, that means value change is taken when new values is averaged to more then 99.3%.

+

?????For Boolean values of 5τ, values is used, that means value change is taken when new values is averaged to more then 99.3%.

==OBD II (Bluetooth) and LVCAN I/O elements==

In OBD II (Bluetooth) column are shown I/O elements which information can be obtained from OBD II Bluetooth dongle connected to FMB120 device and in LVCAN column are shown I/O elements whitch information can be obtained from LV-CAN200 or ALL-CAN300 connected to FMB120 device. All I/O configuration is the same as described in [[FMB120 I/O settings|I/O settings]] section, except OBD II (Bluetooth) I/O element don’t have averaging constant parameter.<br/>Detailed description about LVCAN I/O element configuration described in [[FMB120 CAN adapters|FMB120 with LV-CAN200 and ALL-CAN300 CAN adapters]].

Atabasnikov

0

edits