Changes

'''Step 3'''

'''Step 3'''

Got to I/O element and select Rear Camera state and Front camera State priority to Low.

Go to RS232/RS485 and enable ADAS in order for the configurator to open additional settings.

[[File:Io config.png|alt=|frameless|414x414px]]

[[File:RS232-ADAS-selection.png|alt=|frameless|410x410px]]

 

 

[[File:ADAS-Settings.png|alt=|frameless|410x410px]]

'''Step 4'''

'''Step 4'''

Go to RS232/RS485 and enable DualCam and configure the DualCam image sending setting for your needs.

Go to I/O element and select required or desired parameter priority to Low.

[[File:DualcamRs232.png|alt=|frameless|410x410px]]

[[File:ADAS-IO.png|alt=|frameless|410x410px]]

'''Step 5'''

'''Step 5'''

Dual Cam server settings will be different:

ADAS server settings will be different:

Domain: Will be the same as from Wialon for the device

Domain: Will be the same as from Wialon for the device

Port: 22148

Port: 22297

[[File:Dual cam server 22.jpg|alt=|frameless]]

[[File:ADAS-server.png|alt=|frameless]]

'''Step 6'''

'''Step 6'''

Dual Cam Video settings, for the video settings only select Video frame rate to 30 FPS.

ADAS Video settings, for the video settings only select Video frame rate to 30 FPS.

'''Note:''' Do not activate Video Sending Triggers in the configurator, because if you set this setting and the device triggered video the Wialon platform will not accept it. So only from the Wialon side must be set video commands in the next chapter Wialon settings we will show how to configure it.

'''Note:''' Do not activate Video Sending Triggers in the configurator, because if you set this setting and the device triggered video the Wialon platform will not accept it. So only from the Wialon side must be set video commands in the next chapter Wialon settings we will show how to configure it.