0
edits
Changes
no edit summary
== Main (front) camera unit preparation ==
The main unit comes prepared for bus/large truck setup (cable routing) or vehicles with mostly vertical windshields''.'' To set up the unit for an average truck or passenger vehicle, dismantle partially as shown below:
{| class="wikitable"
|+
! colspan="6" |Unit preparation
|-
|[[File:Camera1.jpg|center|frameless|181x181px]]
|1. Remove cover
|[[File:Camera1.jpg|center|frameless|186x186px]]
|2. Remove (2x) screws,
remove plastic cover
|[[File:Camera3.png|center|frameless|216x216px]]
|3. Remove (2x) screws,
pry plastic mounting
frame off Unit from corners
|-
|[[File:Camera4.png|center|frameless|199x199px]]
|4. Reroute the main
cable (and rear camera
cable, if adding) around unit
to front (glass side)
|[[File:Camera5.png|center|frameless|221x221px]]
|5. Press tightly into
channels when routing cables.
Remove front camera dust sticker
|[[File:Camera6.png|center|frameless|238x238px]]
|6. Replace 1 cover only
removed from step 3.
Replace 2 screws.
Leave the remaining
covers off until the last step
|}
==ADAS Calibration==
==ADAS Calibration==
ADAS Calibration requires:
ADAS Calibration requires: