Changes

The Mobileye 5 CAN interface (CAN Bus) is located in the Main unit (SeeQ/camera). The Typical SeeQ CAN Channel dedicated to FMS Integrations and similar communication is the CAN-A channel. {{{model|FMB6YX}}} devices use CAN1 by default configuration for Mobileye and FM communications.  

The Mobileye 5 CAN interface (CAN Bus) is located in the Main unit (SeeQ/camera). The Typical SeeQ CAN Channel dedicated to FMS Integrations and similar communication is the CAN-A channel. {{{model|FMB6YX}}} devices use CAN1 by default configuration for Mobileye and FM communications.  

<br />[[File:Asset 1 v1.png|600x600px]]

<br />[[File:Fmm 650 2x10 pinout.png|600x600px]]

You need to connect this CAN bus interface to Mobileye CAN-A channel dedicated CAN bus interface for {{{model|FMB6YX}}}. In Mobileye 5 the CAN-A Channel is accessible for physical connection using the CAN-AM Male connector, (6 Pins connector labeled “EyeCAN”) in the Mobileye 5 main harness.  

You need to connect this CAN bus interface to Mobileye CAN-A channel dedicated CAN bus interface for {{{model|FMB6YX}}}. In Mobileye 5 the CAN-A Channel is accessible for physical connection using the CAN-AM Male connector, (6 Pins connector labeled “EyeCAN”) in the Mobileye 5 main harness.  

[[File:Mobileye-scheme (2).png|800x800px]]

[[File:{{{model|FMB6YX}}}-Mobileye-scheme.png|800x800px]]

{{{model|FMB6YX}}} device CAN1 H signal must be connected to “EyeCAN” PIN1 and CAN1 L to PIN2. Please take a note that connectors for FMS devices (in this case {{{model|FMB6YX}}}) are not supplied. This connection cable should be provided for {{{model|FMB6YX}}} CAN1 connection with Mobileye 5 “EyeCAN” port. <br> <br>

{{{model|FMB6YX}}} device CAN1 H signal must be connected to “EyeCAN” PIN1 and CAN1 L to PIN2. Please take a note that connectors for FMS devices (in this case {{{model|FMB6YX}}}) are not supplied. This connection cable should be provided for {{{model|FMB6YX}}} CAN1 connection with Mobileye 5 “EyeCAN” port. <br> <br>