Wiki Knowledge Base | Teltonika GPS

Changes

Template:FTXXX1 Sleep modes (view source)

Revision as of 09:12, 29 May 2023

816 bytes removed ,  09:12, 29 May 2023
no edit summary
Line 6: Line 6:       −
{{{model|FMM6YX}}} is able to go into GPS sleep mode if such mode is enabled.<br/>Sleep mode timeout starts counting when the device is in STOP mode. After timeout is reached and all conditions for GPS sleep mode are met, the device goes into sleep mode.
+
{{{model|FTCXX1}}} is able to go into GPS sleep mode if such mode is enabled.<br/>Sleep mode timeout starts counting when the device is in STOP mode. After timeout is reached and all conditions for GPS sleep mode are met, the device goes into sleep mode.
    
[[Image:FTC921_GPS_sleep.png|350 px]]
 
[[Image:FTC921_GPS_sleep.png|350 px]]
   −
  When in GPS sleep mode, {{{model|FMM6YX}}} turns the GPS module off and continues making new periodic records. As a result power usage decreases, in turn saving vehicle battery.<br/>{{{model|FMM6YX}}} will enter GPS sleep mode if ALL of these conditions are met:
+
  When in GPS sleep mode, {{{model|FTCXX1}}} turns the GPS module off and continues making new periodic records. As a result power usage decreases, in turn saving vehicle battery.<br/>{{{model|FTCXX1}}} will enter GPS sleep mode if ALL of these conditions are met:
   −
*{{{model|FMM6YX}}} is configured to work in GPS Sleep mode and sleep timeout is reached;
+
*{{{model|FTCXX1}}} is configured to work in GPS Sleep mode and sleep timeout is reached;
 
*Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on the “Records saving/sending without TS” parameter:
 
*Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on the “Records saving/sending without TS” parameter:
   −
:*After Position Fix - {{{model|FMM6YX}}} time is synchronized with GNSS satellites and GPS fix is obtained;
+
:*After Position Fix - {{{model|FTCXX1}}} time is synchronized with GNSS satellites and GPS fix is obtained;
−
:*After Time Sync - {{{model|FMM6YX}}} time is synchronized over NTP, NITZ, or GNSS satellites;
+
:*After Time Sync - {{{model|FTCXX1}}} time is synchronized over NTP, NITZ, or GNSS satellites;
−
:*Always - {{{model|FMM6YX}}} will enter sleep mode without time synchronization and GPS fix.
+
:*Always - {{{model|FTCXX1}}} will enter sleep mode without time synchronization and GPS fix.
    
*Movement is not detected by the accelerometer{{{txt_movement| and configured movement source}}};
 
*Movement is not detected by the accelerometer{{{txt_movement| and configured movement source}}};
Line 23: Line 23:     
*There are no SMS messages being received.
 
*There are no SMS messages being received.
 +
   −
{| class="wikitable" style="border-style: solid; border-width: 0px"
+
{{{model|FTCXX1}}} exits GPS sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
−
|+
  −
|-
  −
| style="text-align: left; background: #F6F6FB;" |[[Image:Bw_nb.png|50px]]
  −
| style="text-align: left; background: #F6F6FB;" |On Firmware version older than 03.18.15, the device time has to be synchronized with GNSS satellites and GPS fix has to be obtained in order for the device to enter GPS Sleep mode.
  −
|}
  −
{{{usb_disconnected|}}}
  −
 
  −
{{{model|FMM6YX}}} exits GPS sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
      
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
 
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
Line 38: Line 31:     
==Deep Sleep mode==
 
==Deep Sleep mode==
−
While in deep sleep mode, {{{model|FMM6YX}}} sets the GNSS receiver to sleep mode and turns off GSM/GPRS module (hence it is not possible to wake up the device via SMS). Despite records with the last known coordinate being saved and sent to the AVL server (GSM/GPRS module is turned on to send data and then it is turned off), power usage is decreased to save the vehicle's battery.
+
While in deep sleep mode, {{{model|FTCXX1}}} sets the GNSS receiver to sleep mode and turns off GSM/GPRS module (hence it is not possible to wake up the device via SMS). Despite records with the last known coordinate being saved and sent to the AVL server (GSM/GPRS module is turned on to send data and then it is turned off), power usage is decreased to save the vehicle's battery.
    
[[Image:FTC921_Deep_sleep.png|350 px]]
 
[[Image:FTC921_Deep_sleep.png|350 px]]
   −
Please note that power saving depends on two configurable parameters: ''Send Period'' and ''Minimum Record Saving Period'' in "X on Stop Mode". When records are sent successfully in deep sleep mode, open link timeout counter will be skipped and {{{model|FMM6YX}}} will enter deep sleep mode immediately.<br />Because a lot of functions are disabled in deep sleep mode following I/O elements are disabled from records that are generated in this mode: GSM Signal, GNSS Status, GNSS PDOP, GNSS HDOP, GSM CellID, GSM Area Code, Active GSM Operator{{{txt_IO|, Trip Odometer, Total Odometer, Speed, Fuel Rate GPS, Fuel Used GPS}}} and ICCID.
+
Please note that power saving depends on two configurable parameters: ''Send Period'' and ''Minimum Record Saving Period'' in "X on Stop Mode". When records are sent successfully in deep sleep mode, open link timeout counter will be skipped and {{{model|FTCXX1}}} will enter deep sleep mode immediately.<br />Because a lot of functions are disabled in deep sleep mode following I/O elements are disabled from records that are generated in this mode: GSM Signal, GNSS Status, GNSS PDOP, GNSS HDOP, GSM CellID, GSM Area Code, Active GSM Operator{{{txt_IO|, Trip Odometer, Total Odometer, Speed, Fuel Rate GPS, Fuel Used GPS}}} and ICCID.
−
{{{model|FMM6YX}}} can enter deep sleep mode if ALL of these conditions are met:
+
{{{model|FTCXX1}}} can enter deep sleep mode if ALL of these conditions are met:
   −
*{{{model|FMM6YX}}} is configured in Deep Sleep mode and sleep timeout is reached;
+
*{{{model|FTCXX1}}} is configured in Deep Sleep mode and sleep timeout is reached;
 
*Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on the “Records saving/sending without TS” parameter:
 
*Device time must be synchronized with GPS satellites. From Firmware 03.18.15 version, this condition depends on the “Records saving/sending without TS” parameter:
   −
:*After Position Fix - {{{model|FMM6YX}}} time is synchronized with GNSS satellites and GPS fix is obtained;
+
:*After Position Fix - {{{model|FTCXX1}}} time is synchronized with GNSS satellites and GPS fix is obtained;
−
:*After Time Sync - {{{model|FMM6YX}}} time is synchronized over NTP, NITZ, or GNSS satellites;
+
:*After Time Sync - {{{model|FTCXX1}}} time is synchronized over NTP, NITZ, or GNSS satellites;
−
:*Always - {{{model|FMM6YX}}} will enter sleep mode without time synchronization and GPS fix.
+
:*Always - {{{model|FTCXX1}}} will enter sleep mode without time synchronization and GPS fix.
    
*Ignition (configured ignition source) is off;
 
*Ignition (configured ignition source) is off;
    
*Movement is not detected by the accelerometer{{{txt_movement| or configured movement source}}};
 
*Movement is not detected by the accelerometer{{{txt_movement| or configured movement source}}};
−
*''Min. Record Saving Period'' ({{{ctrDaq|[[{{{model|FMM6YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) must be larger than ''Open Link Timeout'' parameter, so that {{{model|FMM6YX}}} could close GPRS link;
+
*''Min. Record Saving Period'' ({{{ctrDaq|[[{{{model|FTCXX1}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) must be larger than ''Open Link Timeout'' parameter, so that {{{model|FTCXX1}}} could close GPRS link;
−
*The difference between ''Send Period'' ({{{ctrDaq|[[{{{model|FMM6YX}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) and ''Open Link Timeout'' must be more than 90 seconds, so that {{{model|FMM6YX}}} could close GPRS link within at least 90 seconds;
+
*The difference between ''Send Period'' ({{{ctrDaq|[[{{{model|FTCXX1}}} Data acquisition settings|Data Acquisition Mode settings]]}}}) and ''Open Link Timeout'' must be more than 90 seconds, so that {{{model|FTCXX1}}} could close GPRS link within at least 90 seconds;
 
*There are no SMS messages being received;
 
*There are no SMS messages being received;
 
*Data socket(s) are closed;
 
*Data socket(s) are closed;
 
*Data sending is not in progress;
 
*Data sending is not in progress;
−
*FOTA is not in progress.<br />
+
*FOTA is not in progress.<br />  
−
 
  −
{| class="wikitable" style="border-style: solid; border-width: 0px"
  −
|+
  −
|-
  −
| style="text-align: left; background: #F6F6FB;" |[[Image:Bw_nb.png|50px]]
  −
| style="text-align: left; background: #F6F6FB;" |On Firmware version older than 03.18.15, the device time has to be synchronized with GNSS satellites and GPS fix has to be obtained in order for the device to enter Deep Sleep mode.
  −
|}
  −
{{{usb_disconnected|}}}
     −
{{{model|FMM6YX}}} exits deep sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
+
{{{model|FTCXX1}}} exits deep sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
    
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
 
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
Line 82: Line 67:     
Conditions to enter online deep sleep mode are the same as entering deep sleep mode.
 
Conditions to enter online deep sleep mode are the same as entering deep sleep mode.
−
{{{model|FMM6YX}}} exits online sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
+
{{{model|FTCXX1}}} exits online sleep mode if {{{txt_exit|ONE of following conditions}}} is true:
    
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
 
*Movement by accelerometer{{{txt_movement| or configured movement source}}} is detected;
Line 89: Line 74:  
<br>
 
<br>
 
{{{ultra_ds|==Ultra Sleep mode==
 
{{{ultra_ds|==Ultra Sleep mode==
−
Conditions to enter ultra deep sleep mode, where GPS and GSM modem are turned off and device functions are suspended for maximum battery saving, are the same as entering deep sleep mode.<br/>{{{model|FMM6YX}}} exits ultra deep sleep mode only when {{{txtIgnition|DIN1 or movement are}}} detected by accelerometer. Movement source {{{txt_ignition|and Ignition source configuration }}}is not taken into account in this case.}}}
+
Conditions to enter ultra deep sleep mode, where GPS and GSM modem are turned off and device functions are suspended for maximum battery saving, are the same as entering deep sleep mode.<br/>{{{model|FTCXX1}}} exits ultra deep sleep mode only when {{{txtIgnition|DIN1 or movement are}}} detected by accelerometer. Movement source {{{txt_ignition|and Ignition source configuration }}}is not taken into account in this case.}}}
    
[[Image:FTC921_Ultra_sleep.png|350 px]]
 
[[Image:FTC921_Ultra_sleep.png|350 px]]
Retrieved from "https://wiki.teltonika-gps.com/view/Special:MobileDiff/86164"