Line 10: |
Line 10: |
| If you have a vehicle that is not listed in the [[OBD_supported_vehicle_list|'''OBD OEM Supported Vehicle List''']] or you are facing problems with OBD OEM in General - follow the log capturing guide below. | | If you have a vehicle that is not listed in the [[OBD_supported_vehicle_list|'''OBD OEM Supported Vehicle List''']] or you are facing problems with OBD OEM in General - follow the log capturing guide below. |
| ==== Capturing OBD logs from FMX00X with Filters ==== | | ==== Capturing OBD logs from FMX00X with Filters ==== |
| + | #Update the device to the latest firmware available. |
| #Make sure that the FMX00X is [https://www.youtube.com/watch?v=RJllm9verYg&ab_channel=TeltonikaTelematics connected properly] to the OBDII Socket. | | #Make sure that the FMX00X is [https://www.youtube.com/watch?v=RJllm9verYg&ab_channel=TeltonikaTelematics connected properly] to the OBDII Socket. |
| #'''Start vehicle engine'''. | | #'''Start vehicle engine'''. |
− | #Send following '''SMS commands''' to FMX1YX device: | + | #Send following '''SMS commands''' to FMX00X device: |
− | #*If you have set SMS login and password:<code>login pass log2sdfilterset 0;2;3;4;1</code> | + | #*If you have set SMS login and password:<code>login pass log2sdfilterset 0;2;3;4;1</code> |
− | #*If SMS login and password are not set leave two spaces before command: <code><span style="color:#f8f9fa">aa</span>log2sdfilterset 0;2;3;4;1</code> <p>If command <code>log2sdfilterset</code> was sent correctly you should receive SMS Response:<code>Enabled Trace Filters:5</code> then you can restart the device</p> | + | #*If SMS login and password are not set leave two spaces before command: <code><span style="color:#f8f9fa">aa</span>log2sdfilterset 0;2;3;4;1</code> <p>If command <code>log2sdfilterset</code> was sent correctly you should receive SMS Response:<code>Enabled Trace Filters:5</code> then you can restart the device.</p> |
− | # If FW version is <b>03.27.10</b> or higher <code>cpureset</code> command is not necessary to enable the filters. On lower versions <code>cpureset</code> is mandatory.
| |
− | #*<p>If you have set SMS login and password: <code>login pass cpureset</code></p>
| |
− | #*<p>If SMS login and password are not set leave two spaces before command:<code><span style="color:#f8f9fa">aa</span>cpureset</code></p><p>Filter description:</p><p>Filter 0 - default filters (No additional data)</p><p>Filter 4 - turn on CAN adapter filter</p><p>Filter 1 - save installed filters to memory after restart</p>
| |
| #After the SMS response message CAN adapter log capturing has been started. | | #After the SMS response message CAN adapter log capturing has been started. |
| #Wait at least '''5 minutes''' to get enough CAN bus data and '''turn off''' vehicle engine. | | #Wait at least '''5 minutes''' to get enough CAN bus data and '''turn off''' vehicle engine. |