Changes

2. For ''Manual CAN Requests tab'' configuration. In '''Manual CAN0 Request''' will be configured Battery Status message request by the provided documentation. For proper configuration by the protocol, '''Request ID''' should be entered with '''Source addresses''', '''Frame ID''' and '''Priority''' – 18030102, and the payload ''0000000000000002'' to receive all needed information.

2. For ''Manual CAN Requests tab'' configuration. In '''Manual CAN0 Request''' will be configured Battery Status message request by the provided documentation. For proper configuration by the protocol, '''Request ID''' should be entered with '''Source addresses''', '''Frame ID''' and '''Priority''' – 18030102, and the payload ''0000000000000002'' to receive all needed information.

3. Additionally there could be configured request period. As example to receive data each 10 seconds In request period will be written 10

3. Additionally, it can also have request period configured. '''As an example''', to receive data each '''10 seconds''', request period must be set to '''10'''.

[[Image:Manual_can_requests_2.png|center]]<br />

[[Image:Manual_can_requests_2.png|center]]<br />4. Request data length configured as 8 bytes

 

5. Received I/O values are RAW and the user has to decode it. The image below is an example of how it can be decoded using additional software (we have used '''''Busmaster''''' for this):

# Received I/O values are RAW and the user has to decode it. The image below is an example of how it can be decoded using additional software (we have used ''Busmaster'' for this):