690
edits
Changes
Template:FTX88X/FTX9XX System (view source)
Revision as of 07:56, 7 September 2023
, 07:56, 7 September 2023no edit summary
Possible ignition sources:
Possible ignition sources:
'''Power Voltage''' - if voltage is between High Voltage Level and Low Voltage Level (below ''Ignition Settings'' options) - ignition is ON; if voltage is higher than High Voltage Level or lower than Low Voltage Level - ignition is OFF.
More than one ignition source can be selected at the same moment. When there are 2 or more sources selected, at least one condition has to be met to change Ignition status.<br>
<br>
'''Accelerometer''' - if movement sensor detects movement - ignition is ON; if movement is not detected - ignition is OFF;
More than one ignition source can be selected at the same time.
Note:
When there are 2 or more sources selected, at least one condition has to be met to change Ignition status.<br> For Example, if both accelerometer and power voltage are selected, only one of the ignition detection conditions have to be true for ignition to be detected.
<br>
Ignition status is used in power management and the following functionalities: [[{{{model|FTC881}}} Features settings#Over Speeding|Over Speeding]], [[{{{model|FTC881}}} Odometer settings|Trip]] and [[{{{model|FTC881}}} Odometer settings|Odometer settings]].<br>
Ignition status is used in power management and the following functionalities: [[{{{model|FTC881}}} Features settings#Over Speeding|Over Speeding]], [[{{{model|FTC881}}} Odometer settings|Trip]] and [[{{{model|FTC881}}} Odometer settings|Odometer settings]].<br>
<!--'''Note:''' Object motion detection settings, where user can configure {{{txt_num|4}}} ways how {{{model|FTC881}}} detects movement and change its working mode (for more information refer to section {{{ctrDaq|[[{{{model|Template:}}} Data acquisition settings]]}}}). Other functionalities that depend on movement source are: power manager, fuel consumption and trip;}}}-->
<!--'''Note:''' Object motion detection settings, where user can configure {{{txt_num|4}}} ways how {{{model|FTC881}}} detects movement and change its working mode (for more information refer to section {{{ctrDaq|[[{{{model|Template:}}} Data acquisition settings]]}}}). Other functionalities that depend on movement source are: power manager, fuel consumption and trip;}}}-->