Changes

Created page with "===Bluetooth settings configuration=== 300px|right Following are the instructions on how to easily prepare Bluetooth Dongle connection..."
===Bluetooth settings configuration===

[[Image:Fmb120_bt_odbii_settings.png|300px|right]]
Following are the instructions on how to easily prepare Bluetooth Dongle connection to the {{{model_2|FMB}}} device. First we need to configure {{{model_2|FMB}}} device Bluetooth settings. These are the required steps:
* Go to <span style=color:#F6A83E>Bluetooth</span> section similarly to as shown in the figure to the right (position 1).
* Turn on BT Radio by pressing <span style=color:#F6A83E>Enable (visible)</span> (position 2). "Local name" (position 3) will automatically be "{{{model|FMB1YX}}}_last 7 imei digits", you can leave it or type your own name.
* Set ''Security Mode'' (position 4) to <span style=color:#F6A83E>PIN only</span> or <span style=color:#F6A83E>None</span> (you could select <span style=color:#F6A83E>PIN + MAC list</span> or <span style=color:#F6A83E>MAC list only</span> security mode but in this case you need to type external device MAC address in ''Authorized Devices MAC List'' (position 7).
* Set connection mode to <span style=color:#F6A83E>OBDII</span> (position 5).
* Set ''External Name'' as your Bluetooth OBD II device name for proper device identification and connection to it. In this example OBDII device name is "DONGLE", at least 2 characters are needed to recognize it and connect to it. For better and faster adapter identification in network you could enter a full device name. You could check your OBDII adapter Bluetooth name by scanning nearby Bluetooth devices using a mobile phone or a computer with Bluetooth adapter.
* Go to <span style=color:#F6A83E>OBD II</span> in main menu and select priority and others parameters visible in the following figure.

[[Image:Fmb120_odbii_settings.png|800px|none]]

* After all these steps press <span style=color:#F6A83E>Save to device</span> to save configuration (position 8 in the top right hand figure).
* Now you can disconnect {{{model_2|FMB}}} device from the configurator.

===Connecting to Bluetooth OBD II dongle===
----
After this configuration OBDII dongle can be connected to {{{model_2|FMB}}} device. Turn on ignition, then turn on its Bluetooth connection. For pairing follow dongle instructions. OBDII device notification about paired Bluetooth connection depends on the specific model. If you later restart {{{model_2|FMB}}} device it will automatically reconnect to this dongle.

===Supported Bluetooth OBD II dongles===
----
{{{model_2|FMB}}} module works with Bluetooth OBD II dongles which are based on ELM327 or STN1110 chips.<br/>Comparison of these chips is presented in the image below:

[[Image:Elm317_stn1110_comp.png|400px|none]]
0

edits

Navigation menu