Changes

[[File:2 cable location.png|800px|center|Installation location]]

[[File:2 cable location.png|800px|center|Installation location]]

* Main cables, which should be used – twisted pair of violet and white-brown for FMS/CAN and Tachograph connection. Same line is used to read FMS data and to download Tachograph files. Additionally K-line wire for live vehicle data from tachograph is located in same place violet – white wire:

* Main cables, which should be used – twisted pair of violet and white-brown for FMS/CAN and Tachograph connection. The same line is used to read FMS data and to download Tachograph files. Additionally, K-line wire for live vehicle data from the tachograph is located in the same place violet – white wire:

[[File:3 wires.png|800px|center|Locating FMS and K-Line wires]]

[[File:3 wires.png|800px|center|Locating FMS and K-Line wires]]

* Below shown connection of CAN1 pair from FMB6 device to FMS/TACHO line on vehicle and K-line connection to FMB6:

* Below shown the connection of CAN1 pair from FMB6 device to FMS/TACHO line on vehicle and K-line connection to FMB6:

[[File:4 wire meanings.png|800px|center|3 FMS and K-Line connection to FMB6]]

[[File:4 wire meanings.png|800px|center|3 FMS and K-Line connection to FMB6]]

* To get proper ressistence on CAN circut, needed to disconnected resistence connector which is near tachograph:

* To get proper resistance on the CAN circuit, needed to disconnect the resistance connector which is near the tachograph:

[[File:5 tacho resistor location.png|800px|center|Resistence connector location]]

[[File:5 tacho resistor location.png|800px|center|Resistence connector location]]

<br>

<br>

After installation and device configuration of FMB6 (CAN1 should be seletected – FMS/TACHO), you can check if instalation is properly made. Turn on ignition of vehicle and send sms command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.

After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if the installation is properly made. Turn on the ignition of the vehicle and send SMS command: “tachocheck”. If the response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.

[[Category:FMB640 Manual]]

[[Category:FMB640 Manual]]