Changes

MSP500 Accelerometer Features settings (view source)

Revision as of 12:27, 12 April 2021

192 bytes removed ,  12:27, 12 April 2021
no edit summary
Line 11: Line 11:  
<br>
 
<br>
 
Note: moving forward along any axis will generate negative values. This means acceleration will generate -X values, accordingly breaking will generate X values. Same goes for other axes. <br>
 
Note: moving forward along any axis will generate negative values. This means acceleration will generate -X values, accordingly breaking will generate X values. Same goes for other axes. <br>
−
  −
Configurable parameters can be found at [[{{{model|MSP500}}}_System_settings#Accelerometer_Auto_Calibration|System Settings Accelerometer Auto Calibration]]
      
Commands that can be used during calibration:<br>
 
Commands that can be used during calibration:<br>
Line 29: Line 27:  
|}
 
|}
 
</center>
 
</center>
−
====Auto calibration before firmware version 03.25.07.Rev.00.====
+
====Auto calibration Source====
 
Accelerometer auto calibration functionality has one purpose - determine how MSP500 device
 
Accelerometer auto calibration functionality has one purpose - determine how MSP500 device
 
is mounted in a vehicle. After the calibration process ''eco driving'' functionality becomes active
 
is mounted in a vehicle. After the calibration process ''eco driving'' functionality becomes active
Retrieved from "https://wiki.teltonika-gps.com/view/Special:MobileDiff/64335"

Navigation menu