{{Template:FMB1 First start card|model=FMB120|description=GNSS/GSM/Bluetooth tracker with internal GNSS/GSM antennas and internal battery||pic=[[Image:FMB120_600X600_1.png|400px|right]]|dual_sim=|sim_pin=[[FMB120 Security info|'''Security info''']]}}
{{Template:FMB1 First start card|model=FMB120|description=GNSS/GSM/Bluetooth tracker with internal GNSS/GSM antennas and internal battery||pic=[[Image:FMB120_600X600_1.png|400px|right]]|dual_sim=|sim_pin=[[FMB120 Security info|'''Security info''']]}}
−
== '''Battery placement after complete device disassemble''' ==
−
[[File:Battery placement.png|left]]
−
[[File:Pcb placement.png|right|frameless]]
−
<br />
−
<br />
−
# Using double sided tape, stick internal battery to the bottom part of the device case. Battery should be glued approximately 15 millimeters from the bottom wall of the case. ''Picture on the left''.
−
# Connect battery to the PCB.
−
# Place PCB into the bottom case by firstly inserting PCB part where antenna is located.
−
'''Note:''' be gentle and careful not to damage or bend antenna.