Changes

==Installation==

==Installation==

To connect the DualCam to a supported device, you have to make sure to connect 4 PINs of the camera to the PINs of your device correctly.

To connect the DualCam to a supported device, you have to make sure to connect 4 PINs of the camera to the PINs of your device correctly.

'''NOTE:''' Dual Cam must be connected to the ignition source or another source, where then you turn off ignition camera will turn off in another case camera will drain the battery if you connect directly.

'''NOTE:''' Dual Cam must be connected to the ignition source or another source, where then you turn off ignition camera will turn off in another case camera will drain the battery if you connect directly.

[[File:Dualcamreley.png|frameless|928x928px]]

[[File:443035 Teltonika DualCam Wiki Knowledge Base Teltonika GPS 1.2.jpg|frameless|928x928px]]

Also, it is possible to connect DualCam to a power source using the relay, to control the power supply and turn on/off the camera. If you need to send information to the server then power off ignition of car. Or also if you do not need to record you can not turn on the camera power.

Also, it is possible to connect DualCam to a power source using the relay, to control the power supply and turn on/off the camera. If you need to send information to the server then power off ignition of car. Or also if you do not need to record you can not turn on the camera power.

[[File:443035 Teltonika DualCam Wiki Knowledge Base Teltonika GPS 1.2.jpg|frameless|928x928px]]

[[File:Reley.png|frameless|928x928px]]

{| class="wikitable"

{| class="wikitable"