Changes

If the equipment does not receive information from the thermographer, the speed of the port accessing the configuration menu:

If the equipment does not receive information from the thermographer, the speed of the port accessing the configuration menu:

Keep the blue and red buttons pressed at the same time. "Enter PIN code" is displayed in screen, enter pin "1111" by pressing the blue button four times. Travel for the options with the red button.

Keep the blue and red buttons pressed at the same time. "Enter PIN code" is displayed on the screen, enter pin "1111" by pressing the blue button four times. Travel for the options with the red button.

The ENG Display> OFF option must be ON, change its value with the keys ◄ and ►. Once switched to ON, keep scrolling through the options until find Baud Rate> 9600. The value should be 9600, otherwise adjust the speed by moving the cursor with the ◄ and ► keys, and adjust speed with the keys ▲ and ▼.

The ENG Display> OFF option must be ON, change its value with the keys ◄ and ►. Once switched to ON, keep scrolling through the options until you find Baud Rate> 9600. The value should be 9600, otherwise, adjust the speed by moving the cursor with the ◄ and ► keys, and adjust the speed with the keys ▲ and ▼.

AVL IDs for Touchprint:

AVL IDs for Touchprint:

See ThermoKing Configuration.

See ThermoKing Configuration.

==='''Carrier Datacold 600 ===

==='''Carrier Datacold 600'''===

To properly use DataCold 600 with FMX640 these steps must be followed:

To properly use DataCold 600 with FMX640 these steps must be followed:

*In FMX640 RS232 settings '''DataCold mode''' is selected and '''Baudrate set to 38400'''

*In FMX640 RS232 settings '''DataCold mode''' is selected and '''Baudrate set to 38400'''

| 3

| 3

|}

|}

==='''Euroscan'''===

==='''Euroscan'''===