Changes

If the Static navigation filter is disabled, it will apply no changes to GPS data. If the Static navigation filter is enabled, it will filter changes in GPS position if no movement (configured movement source) or ignition (configured ignition source) is detected (depends on what static navigation settings are selected: movement, ignition or both sources). It allows filtering GPS jumps when an object is parked (is not moving) and GPS position is still traced.<br></br>

If the Static navigation filter is disabled, it will apply no changes to GPS data. If the Static navigation filter is enabled, it will filter changes in GPS position if no movement (configured movement source) or ignition (configured ignition source) is detected (depends on what static navigation settings are selected: movement, ignition or both sources). It allows filtering GPS jumps when an object is parked (is not moving) and GPS position is still traced.<br></br>

==Sleep Mode==

==Sleep Mode==

 

===BT/BLE module OFF during Sleep modes===

Sleep Settings:<br>

This feature will be used to save power consumption of external battery (power supply). It let the user choose one of four power saving modes which he would prefer: '''[[{{{model|FMB1YX}}} Sleep modes#GPS Sleep mode|GPS Sleep]]''', '''[[{{{model|FMB1YX}}} Sleep modes#Deep Sleep mode|Deep Sleep]]''', '''[[{{{model|FMB1YX}}} Sleep modes#Online Deep Sleep mode|Online Deep Sleep]]''' and '''[[{{{model|FMB1YX}}} Sleep modes#Ultra Deep Sleep|Ultra Deep Sleep]]'''.<br><br>

Power off sleep mode can be described as the lowest possible power consumption mode where the device can go into power off state.

After timeout is reached and all conditions for sleep mode are met, the device goes to sleep mode.<br>

 

'''Note:''' Detail description and conditions about every mode you can find [[{{{model|FMB1YX}}} Sleep modes|'''here''']].<br><br>

From the version, 03.28.XX this new functionality includes new parameters:

 

Option added from firmware version '''03.27.10.Rev.487''', allows to adjust default exit of sleep conditions. Some of the settings work only on specific sleep modes:

*'''Periodic Wakeup''' – if value is greater than zero, device while being in Deep Sleep or Online Deep Sleep, will wake up after defined period for beacon collection. This is mainly should be used when Bluetooth is disabled in sleep.

*'''Bluetooth On While In Sleep'''- by default this parameter value is set to Enable and BT will work as in base functionality. If this value is set to Disable, Bluetooth will be turned off when device goes to Deep Sleep or Online Deep Sleep and will be turned on during Periodic Wakeup or if device enters normal state.

* Accelerometer (instant movement) only affects Ultra and Power off sleep modes;

[[Image:PWU.jpg|right|300px]]

* DIN1 only affects Ultra and Power off sleep modes. DIN1 shows up as a wakeup source if device has DIN1. FMB965/FMB930 will wake up from Power off sleep if a signal is applied to DIN1 no matter how this option is configured;

</br></br>

* Power voltage doesn‘t affect FMB devices. FMB965/FMB930 will wake up from Power Off sleep from an applied external voltage no matter how this option is configured;

 

* For selected sleep mode only applicable „Wake up source“ options are available.<br></br>

Note: In case when during scan after wakeup no BLE devices will be found FMB will be active for configured scan duration time in Bluetooth 4.0 tab. After that timeout FMB will go to sleep state.

<br>

 

Power off sleep mode can be described as the lowest possible power consumption mode where the device can go into power off state and can only wake up if one of the conditions is true:

 

*Movement is detected by accelerometer (not by the configured movement source);

*External power is applied;

*It is the time to make a new periodic record (new feature);

<br>

==Ignition Source==

==Ignition Source==