322
edits
Changes
no edit summary
*'''Do not forget''' to configure ''DashCam'' server information. In '''RS232\RS485''' fill in '''DashCam Server Settings''' with ''Domain'' and ''Port'' entries.
*'''Do not forget''' to configure ''DashCam'' server information. In '''RS232\RS485''' fill in '''DashCam Server Settings''' with ''Domain'' and ''Port'' entries.
[[File:Dashcamserver.png|600px]]
[[File:Dashcamserver.png|600px]]
'''DASHCAM FMC650 Configuration'''
[[Firmware_versions#PROFESSIONAL_trackers|'''(!) Required firmware version''']]. [[FMC650_firmware_errata|Firmware errata.]]
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
[[Image:Data_protocol.gif|300px]]
*In ''RS232 \ RS485 settings tab'', make sure to choose '''DashCam''' to '''COM1/COM2 settings''', and set the required '''baudrate'''.
[[Image:Dashcam rs232.png|600px]]
*Make sure to change '''I/O''' Camera state '''Priorities''' to ''Low''
'''
[[File:Io.gif|500px]]
'''
*As soon as '''DashCam''' is selected, ''COM1 Camera'' and ''Camera I/O settings'' tabs will appear in the configurator menu.
[[Image:Dashcam settings camera io.png|600px]]
*In appeared ''COM1 Camera tab'', make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DashCam" Scenario Settings''
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
''
''
