Template:FTX Accessories: Difference between revisions
Irmantas.K (talk | contribs) Created page with "=Wired accessories= ==1-Wire settings== alt=|right|500px Set up a sequence of 1-Wire sensors by your needs. This sequence affects how temperature values will be sent to the server using I/O elements. {{#switch: {{{model|FTC305}}} | FTC305 | FTM305 = ==CAN== alt=|right|500px CAN settings. Controls CAN speed, etc. }}" |
Irmantas.K (talk | contribs) No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Wired accessories= | =Wired accessories= | ||
<!-- If model supports CAN, then show --> | |||
{{#if: {{FTX Pin Support List|model={{{model}}}|pin=CAN}} | | |||
{{# | |||
| | |||
| | |||
==CAN== | ==CAN== | ||
[[File:FTX CAN.png|alt=|right|500px]] | [[File:FTX CAN.png|alt=|right|500px]] | ||
CAN settings. | Configurable CAN settings: | ||
*'''Baudrate selection''': | |||
**'''Auto''' - allows user to detect CAN bus baudrate automatically. | |||
**'''Manual''' - allows user to select baudrate manually. | |||
*'''Nominal baudrate (kbps)''' - can be chosen only when Manual baudrate is used: | |||
**Selection from '''33''' to '''2000 kbps''' (10 possible values). | |||
*'''Data baudrate (kbps)''' - can be chosen only when Manual baudrate is used: | |||
**Selection from '''33''' to '''2000 kbps''' (10 possible values). | |||
**Available only with FDCAN. | |||
*'''Termination resistor''' - allows to control 120 Ohm termination resistor: | |||
**Disable | |||
**Enable. | |||
}} | }} | ||
<!-- TBD | |||
==1-Wire settings== | |||
[[File:FTX 1-wire settings.png|alt=|right|500px]] | |||
Configure the sequence of 1-Wire sensors as needed. This sequence determines how temperature values are sent to the server via I/O elements. | |||
--> | |||
[[Category:{{{model}}} Configuration]] | |||
Revision as of 20:11, 27 March 2025
Wired accessories
[[Category:{{{model}}} Configuration]]