Latest revision as of 14:16, 12 November 2025

Wired accessories

[[Category:{{{model}}} Configuration]]

@@ Line 1: / Line 1: @@
 =Wired accessories=
-<!-- If model supports Manual CAN, then show -->
+<!-- If model supports AIN, then show -->
-{{#switch: {{{model|FTC305}}}
+{{#if: {{FTX Pin Support List|model={{{model}}}|pin=AIN1}} |
-| FTC305
+==Analog Fuel Sensor==
-| FTM305 =
+[[File:Fuel Gauge.png|alt=|frameless|200x200px]]
-==CAN==
+Fuel tracking is one of the key challenges of fleet management. If the vehicle has a factory installed Analog Fuel Sensor, there is a solution that does not require any additional equipment - you can connect the device via AIN to read the fuel data straight from the sensor
-[[File:FTX CAN.png|alt=|right|500px]]
-Configurable CAN settings:
-*'''Baudrate selection''':
+*[[Analog Fuel Sensor|Analog Fuel Sensor]]
-**'''Auto''' - allows user to detect CAN bus baudrate automatically.
+}}
-**'''Manual''' - allows user to select baudrate manually.
-*'''Nominal baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
-**Selection from '''33''' to '''2000 kbps''' (10 possible values).
-*'''Data baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
-**Selection from '''33''' to '''2000 kbps''' (10 possible values).
-**Available only with FDCAN.
-*'''Termination resistor''' - allows to control 120 Ohm termination resistor:
+{{#if: {{FTX Pin Support List|model={{{model}}}|pin=1-Wire}} |
-**Disable
-**Enable.
-}}
-<!-- TBD
 ==1-Wire settings==
 [[File:FTX 1-wire settings.png|alt=|right|500px]]
-Configure the sequence of 1-Wire sensors as needed. This sequence determines how temperature values are sent to the server via I/O elements.
+-Wire settings allow you to set up a sequence of 1-Wire sensors according to your needs. This sequence affects how the temperature values measured by the sensors are sent to the server using I/O elements. The user can upload, preview and delete a .csv file with up to 10000 device IDs. Up to five 1-Wire sensors from the list can be read in a user-defined sequence and their data sent to the server.
--->
+}}
 [[Category:{{{model}}} Configuration]]