(124 intermediate revisions by the same user not shown)
Line 1:
Line 1:
==Ignition settings==
[[File:Dead Reckoning vibration could cause unwanted device movements.png|thumb|left|300px|link=Special:Redirect/file/Dead Reckoning vibration could cause unwanted device movements.png|Places, where vibration could cause unwanted device movements]]
[[File:FTC_ignition_resized.gif|right]]
Ignition source will be used to determine the ignition status of the vehicle.
Possible ignition sources:
<!-- If model supports DIN1/DIN2/DIN3, then show -->
{{#if: {{FTX_Pin_Support List|model={{{model}}}|pin=AIN1}} | AIN1 YES }} {{#if: {{FTX Pin Support List|model={{{model}}}|pin=1-Wire}} | 111 W |NO WIRE }} {{#if: {{FTX Pin Support List|model={{{model}}}|pin=DIN3}} | * '''DIN 3''' - If DIN3 is 1 - ignition is ON; if DIN3 value is 0 - ignition is OFF }}
* '''Power Voltage''' - if the voltage is between High Voltage Level and Low Voltage Level (below ''Ignition Settings'' options) - ignition is ON; if the voltage is higher than High Voltage Level or lower than Low Voltage Level - ignition is OFF.
* '''Accelerometer''' - if movement sensor detects movement - ignition is ON; if movement is not detected - ignition is OFF;
More than one ignition source can be selected at the same time.
Latest revision as of 10:22, 24 April 2026
Places, where vibration could cause unwanted device movements
