Latest revision as of 15:35, 15 May 2026

Wired accessories

[[Category:{{{model}}} Configuration]]

@@ Line 2: / Line 2: @@
 <!-- If model supports AIN, then show -->
 {{#if: {{FTX Pin Support List|model={{{model}}}|pin=AIN1}} |
+{{#switch: {{{model}}}
+| #default =
 ==Analog Fuel Sensor==
 [[File:Fuel Gauge.png|alt=|frameless|200x200px]]
@@ Line 8: / Line 10: @@
 *[[Analog Fuel Sensor|Analog Fuel Sensor]]
+| FTC308
+| FTM308 =
+}}
 }}
-<!-- If model supports CAN, then show -->
-{{#if: {{FTX Pin Support List|model={{{model}}}|pin=CAN}} |
-==CAN==
-[[File:FTX CAN.png|alt=|right|500px]]
-Configurable CAN settings:
-*'''Baudrate selection''':
-**'''Auto''' - allows user to detect CAN bus baudrate automatically.
-**'''Manual''' - allows user to select baudrate manually.
-*'''Nominal baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
-**Selection from '''33''' to '''2000 kbps''' (10 possible values).
-*'''Data baudrate (kbps)''' - can be chosen only when Manual baudrate is used:
-**Selection from '''33''' to '''2000 kbps''' (10 possible values).
-**Available only with FDCAN.
-*'''Termination resistor''' - allows to control 120 Ohm termination resistor:
-**Disable
-**Enable.
-}}
 {{#if: {{FTX Pin Support List|model={{{model}}}|pin=1-Wire}} |
 ==1-Wire settings==