Difference between revisions of "FMB900 Status info"
From Wiki Knowledge Base | Teltonika GPS
(Created page with "{{Template:FMB1 LED status|model=FMB900}}") |
|||
(5 intermediate revisions by 3 users not shown) | |||
Line 1: | Line 1: | ||
− | {{ | + | {{Template:FMB1 LED status|model=FMB900}} |
− | Template: | ||
− | |model=FMB900 | ||
− | |||
− | |||
− | |||
− |
Revision as of 09:10, 24 May 2018
Main Page > Basic Trackers > FMB900 > FMB900 Configuration > FMB900 Status infoThis section is an explanation of LED indications on an FMB900 device.
Behaviour | Meaning |
---|---|
Permanently switched on | GNSS signal is not received |
Blinking every second | Normal mode, GNSS is working |
Off | GNSS is turned off because: Device is not working or Device is in sleep mode |
Blinking fast constantly | Device firmware is being flashed |
Status LED Indications
Behaviour | Meaning |
---|---|
Blinking every second | Normal mode |
Blinking every two seconds | Sleep mode |
Blinking fast for a short time | Modem activity |
Off | Device is not working or Device is in boot mode |
CAN Status LED indications
Behaviour | Meaning |
---|---|
Blinking fast constantly | Reading CAN data from vehicle |
Permanently switched on | CAN unit unresponsive |
Off | Wrong program number or wrong wire connection or CAN processor is in sleep mode = CAN data not received |