Changes

<br>

<br>

Data Acquisition Type – defines when to generate event – when value enters defined range, exits it or both, also is possible to select event which you want to generate then you change values, like crossing both values in high and low levels (Hysteresis). High and Low levels – defines CAN value range. If CAN value enter or exits this range, {{{model|FM36YX}}} generates event by “Data Acquisition Type” settings. Figure below show example of {{{model|FM36YX}}} CAN configuration.

Data Acquisition Type – defines when to generate event – when value enters defined range, exits it or both, also is possible to select event which you want to generate then you change values, like crossing both values in high and low levels (Hysteresis). High and Low levels – defines CAN value range. If CAN value enter or exits this range, {{{model|FM36YX}}} generates event by “Data Acquisition Type” settings. Figure below show example of {{{model|FM36YX}}} CAN configuration.

 

<br> [[File:FM36XX_Configurator_LVCAN.png|800px]] <br>

<br> [[File:FM36XX_Configurator_LVCAN.png|800px]] <br>

Available CAN Bus IO parameters and configuration can be found in Configurators CAN tab (Figure above) and in  “Parameters ID”. ?????

Available CAN Bus IO parameters and configuration can be found in Configurators CAN tab (Figure above) and in  “Parameters ID”.

<br><br>

<br><br>

All information about I/O element parameters description is in section [[{{{model|FM36YX}}} I/O settings|I/O settings]].<br/>All LV-CAN200/ALL-CAN300 I/O parameters configuration settings are described in "{{{model|FM36YX}}} Protocols" document, except ALL-CAN300 bitmasks, which are described in the table below.''

All information about I/O element parameters description is in section [[{{{model|FM36YX}}} I/O settings|I/O settings]].<br/>All LV-CAN200/ALL-CAN300 I/O parameters configuration settings are described in "{{{model|FM36YX}}} Protocols" document, except ALL-CAN300 bitmasks, which are described in the table below.''

===Example===

===Example===

When using older connection schemes where program number displayed as 3-digit program number:

When using older connection schemes where program number displayed as 3-digit program number:

[[Image:Fmb120_can_prog_number.png|600px|center]]

[[Image:FM36M1_can_prog_number.png|600px|center]]

Using LV-CAN200/ALL-CAN300 Bootloader from soft version 2017-09-27 it is necessary to add "1" to the front of program number:

Using LV-CAN200/ALL-CAN300 Bootloader from soft version 2017-09-27 it is necessary to add "1" to the front of program number:

[[Image:Fmb120_can_updater.png|400px|center]]

[[Image:Fmb120_can_updater.png|400px|center]]