Difference between revisions of "FMA setdigout"
From Wiki Knowledge Base | Teltonika GPS
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Template:FMB FW development notice}} | {{Template:FMB FW development notice}} | ||
| − | |||
Sets digital outputs to ON or OFF state (for some time if needed). Value is written as a row for OUT1 and OUT2 values. | Sets digital outputs to ON or OFF state (for some time if needed). Value is written as a row for OUT1 and OUT2 values. | ||
| Line 9: | Line 8: | ||
<br/><br/> | <br/><br/> | ||
'''Example:'''<br/>"setdigout ?1" will set OUT2 to high level for indefinite period of time while OUT1 remains as it was set before. | '''Example:'''<br/>"setdigout ?1" will set OUT2 to high level for indefinite period of time while OUT1 remains as it was set before. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 15:12, 22 August 2018
Sets digital outputs to ON or OFF state (for some time if needed). Value is written as a row for OUT1 and OUT2 values.
Example:
"setdigout 01 0 5" will set OUT2 to high level for 5 seconds, while OUT1 to low level.
To ignore one digital output value and make ON/OFF state only to another digital output enter question mark.
Example:
"setdigout ?1" will set OUT2 to high level for indefinite period of time while OUT1 remains as it was set before.
