Difference between revisions of "FMB206 Installation instruction"
m (Protected "FMB206 Installation instruction" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
(Created page with "{{ Template:FMB2_Installation_instruction |model=FMB206 }} Category:FMB206 Manual") |
(No difference)
| |
Revision as of 13:43, 27 September 2019
FMB206 Manual > FMB206 Installation instructionPossible mounting zones
Trucks
It is strongly recommended to mount FMB206 outside of the vehicle with the sticker direction to the sky.
Most commercial trucks have plastic hood in front of the vehicle. It is recommended to mount FMB206 under the hood. Power cord output of the device should be at the bottom. If it is not possible, if a front hood is made of some kind of metal, the device can be mounted inside the car on the front panel as close as possible to the front window.
Tractors
It is strongly recommended to mount FMB206 outside of the vehicle with the sticker direction to the sky.
Motor bikes
FMB206 device should be mounted on outside.
FMB206 cannot be mounted under the seat!
Light vehicles
Most light vehicles has oblique front window that opens most part of interior front panel. FMB206 can be mounted under the plastic panel behind the front window, with the sticker
direction to a window (sky).
Recommended mounting positions
Best FMB206 mounting position is outside of vehicle with any metal above the device.
Recommended deviation from horizontal axis of vehicle max 3-5°.
Mounting position and recommended deviation from longitudinal axis of vehicle ±2°.
Restrictions
FMB206 device can not be mounted inside in the vehicle door!
FMB206 device cannot be mounted inside the vehicle!
Connecting power wires
- Device should be connected directly to battery. Power supply: 6V/12V/24V.
- If FMB206 is used in 6V system and power cables are extended.
Extension cable resistance should be less than 60 mΩ in sum of both, positive and negative, wires. 30 mΩ for single wire.
