Difference between revisions of "FM3001 SMS events"

From Wiki Knowledge Base | Teltonika GPS
m (Protected "FM3001 SMS events" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite)))
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
 
{{Template:FMB SMS events|model=FM3001|SMS_Call_1=SMS_Call_1.png}}
 
{{Template:FMB SMS events|model=FM3001|SMS_Call_1=SMS_Call_1.png}}
 +
[[Category:FM3001 Configuration]]

Latest revision as of 20:43, 15 October 2019

Main Page > EOL Products > FM3001 > FM3001 Configuration > FM3001 SMS events

SMS Events

From firmware version 03.29.00.Rev.00 improvement in configuring SMS events is made. SMS event configuration will be available in a single tab, which would allow more flexible FM3001 configuration, and improved visibility and readability of configured parameters. Additionally, now it is possible to send a SMS notification to multiple phone numbers simultaneously.

SMSEventBefore.gif

Note: These changes effect SMS events configuration for I/O elements and Manual Geofence only. SMS events configuration logic is not changed for Features and Acc.Features.

SMS events functionality allows FM3001 to send a configured SMS when an event is triggered. This event can be triggered by every I/O element.
When any of the I/O elements are triggered, FM3001 sends a configured SMS message to a defined phone number.

FMB640 predef numlxist.png

FM3001 is able to send SMS messages to Predefined phone numbers (recipients) if any of the selected events are triggered. Users can send SMS alert messages of selected events to a maximum of 10 predefined phone numbers. AVL ID of the parameter has to be entered in the configuration to receive its SMS event. AVL ID list is defined and available each device wiki page under "Teltonika Data Sending Parameters ID" tab.


Predefined phone numbers must be entered in the SMS Events Numbers list in the ‘SMS \ Call Settings’ menu before it will be possible to pair them with AVL ID and SMS event text.

SMS Event Text is used to add additional text to standard SMS event message text.

Bw nb.png If FM3001 is in Deep Sleep mode and an SMS event occurs with Low priority (which does not wake up FM3001), then the device does not send the message. It is saved to device memory until it wakes up from Deep Sleep mode and GSM modem starts working normally. After it wakes up, all the messages that are saved to memory will be sent, but keep in mind that only 10 messages can be saved to memory – all other messages will not be saved, until there is free memory space.

SMS Events in older versions

SMS events functionality allows FM3001 to send a configured SMS when an event is triggered. This event can be triggered by every I/O element.
When any of the I/O elements is triggered, FM3001 sends a configured SMS message to a defined phone number. If SMS events are activated but there are no numbers defined in GSM Predefined Numbers list (similarly as in the picture below), then the device will not send any messages.

SMS Call 1.png

The sent SMS messages format is following:
"Date Time Current Coordinate Event Text"
For example, if FM3001 is configured to send an SMS, when Ignition reaches high level while configured with High priority and event generation is set to both range entrance and exit (as shown in the figure below), then the following SMS is sent:
"2017/06/13 13:52:18 Lon:25.255537 Lat:54.667193 Ignition 1"

FMB120 SMS events.png

The SMS Text field can be altered and any text can be entered. Maximum message length is 160 symbols (numbers, letters and symbols in ASCII, except for comma symbol ",").