Difference between revisions of "FMB910 Accessories"
From Wiki Knowledge Base | Teltonika GPS
m (Protected "FMB910 Accessories" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
|||
| (5 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | {{Template:Accessories|model= | + | {{Template:FMB9 Accessories|model=FMB910|pic_ds1820=[[Image:Sch_fmb120_ds1820.png|400px|center]]|oneWire=}} |
| − | | | + | <!--[[Category:FMB910 Manual]]--> |
| − | | | ||
| − | | | ||
| − | | | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | [[Category:FMB910 Manual | ||
Revision as of 08:15, 31 January 2020
Main Page > Basic Trackers > FMB910 > FMB910 Manual > FMB910 Accessories
|
Please order accessories separately as they are not included into device package. |
| Accessory and its description | Accessory connection schematic |
|---|---|
| Fuel tank sensors | Fuel sensor connection to FMB910 |
| A fuel tank level sensor which indicates the approximate fuel level on the driver's indicator panel exists in most cars. If the sensor returns analogue signal proportional to fuel level it can be connected to FMB910 Analog input. After connection to the tank fuel level sensor a calibration is needed because most fuel tank sensors are not linear. Calibration is performed by measuring voltage values resulting from the volume of fuel in tank. |  |
| Alarm buttons, door sensors etc. | Panic button connection to FMB910 |
| Alarm buttons, door sensors, ignition, etc. have two output states: high or low. FMB910 Digital inputs are used to detect these states. |  |
| Relays | Inverting relay connection to FMB910 |
| In cases when sensor output signal is negative, an additional relay has to be installed to convert negative signal to positive. |  |
| Immobilizer relay | Immobilizer relay connection to FMB910 output |
| When connected as shown on the right hand side, FMB910 disables engine starter when output is ON. |  |
| Automotive relay | Automotive relay pinout |
An ordinary automotive relay is used to invert input signal or to immobilize engine starter. Note that relays can be 12 V or 24 V capable. |
 |
