3,231
edits
Changes
→Alternative DDD download
==CAN \ Tachograph==
==CAN \ Tachograph==
'''CAN \ Tachograph''' are used to configure device when connection of CAN1 and CAN2 BUS lines are performed. <br>
Teltonika recommendations: <br>
* FMB640 CAN1 connected to vehicle's FMS(J1939) BUS line<br>
* FMB640 CAN2 connected to vehicle's Tachograph - Instructions can be found on [[FMB640_and_Tachograph_Solution|FMB640 and Tachograph Solution]] wiki page;
==Tachograph Settings==
==Tachograph Settings==
Tachograph ignition source – which DIN is connected to vehicle ignition ("Ignition" parameter - tachograph ignition source will be the same as configured in "System" -> "Ignition Source");<br />
Tachograph ignition source – which DIN is connected to vehicle ignition ("Ignition" parameter - tachograph ignition source will be the same as configured in "System" -> "Ignition Source");<br />
<br />
<br />
[[image:FMB640_Tachograph_settings2.gif]]
FMB640 can be wired to Tachograph using instructions provided in [[FMB640_and_Tachograph_Solution|FMB640 and Tachograph Solution]] wiki page.
'''Alternative DDD download'''
Enables the possibility to download specific DDD driver and co-driver card data from non-original locations. It may include last download information.
NOTE: Alternative DDD download '''WILL NOT''' work with GEN2 Tachographs (VDO 4.0 or Stoneridge SE5000 8.0)
By default, this parameter is DISABLED.
==WEB Tacho Settings==
==WEB Tacho Settings==
==FMS settings==
==FMS settings==
FMS settings is used to configure FMS source. <br><br>
If you have FMS wired to FMB640 CAN1, FMS source should be selected as CAN1.<br>
If you have FMS wired to FMB640 CAN2, FMS source should be selected as CAN2.
[[image:FMB640_FMS_settings.gif]]
[[Category:FMB640 Configuration]]