FMP100 GSM Operators settings: Difference between revisions

From Teltonika Telematics Wiki
No edit summary
No edit summary
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
{{Template:FMB GSM Operators settings|model=FMP100|ctrDaq=[[FMB120 Data acquisition settings|Data acquisition settings]]|dual_sim=}}
{{Template:FMB GSM Operators settings|model=FMP100|ctrDaq=[[FMB120 Data acquisition settings|Data acquisition settings]]|dual_sim=}}


<!--[[Category:FMP100 Configuration]]-->
[[Category:FMP100 Configuration]]

Latest revision as of 10:13, 6 January 2021

Main Page > Fast & Easy Trackers > FMP100 > FMP100 Manual > FMP100 Configuration > FMP100 GSM Operators settings

GSM settings

Operator lists

FMP100 can work in different modes (use different settings) according to the operator list defined. Operator list is used for Data Acquisition mode switching (see Data acquisition settings section for more details). Modes are changed based on the GSM operator FMP100 is connected to.

Configuring device roaming and blacklist operators is recommended to optimize device performance by mitigating additional latency.

If the roaming operator list is left empty, FMP100 will automatically detect the home operator. If the home operator is written to the roaming operator list, it will still be detected as a home operator. Any operator not in the roaming operator list (except the home operator) will be recognized as an unknown operator and FMP100 will work in Unknown mode (make sure it is configured to allow data sending – GPRS context is enabled).
If the user wants FMP100 to not connect and work with a particular operator it has to be written to Operator Blacklist. Up to 50 operators may be entered into this list.

The Operator search procedure is initiated every 15 minutes. During the search, FMP100 tries to connect to the operator providing the strongest signal. It will prioritize operators that are specified in the operator list. If no operators from the operator list are available, the device will try to connect to an operator from the blacklist. If the device connects to an operator from the blacklist, the best operator search procedure is initiated instantly. During the time when the device is connected to a blacklisted operator, no GPRS connection would be initiated and no data would be sent via GPRS. However, the ability to send SMS commands to the device would remain. If no suitable operator is found on both lists, the device will try to connect to a remaining available operator with the strongest signal.