Difference between revisions of "Upgrading CAN-CONTROL to CAN-CONTROl+Immobilizer"
From Wiki Knowledge Base | Teltonika GPS
| (3 intermediate revisions by the same user not shown) | |||
| Line 5: | Line 5: | ||
* Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''". | * Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''". | ||
| − | If You | + | If You endure with any of these issues - we offer a perfect solution. |
== Solution == | == Solution == | ||
| − | After installation is | + | After installation is complete and CAN bus adapter program is set, please, follow these steps: |
# Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times'''; | # Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times'''; | ||
| Line 15: | Line 15: | ||
# After receiving a response to a command, repeat the learning procedure (first step). | # After receiving a response to a command, repeat the learning procedure (first step). | ||
| + | '''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]]. | ||
| − | |||
| − | |||
| − | |||
After completed these steps, commands to open/close and to block/unblock engine can be performed. | After completed these steps, commands to open/close and to block/unblock engine can be performed. | ||
| − | |||
| − | |||
| − | + | All SMS/GPRS responses should inform You that particular command has been completed successfully. | |
| − | + | ||
| − | + | '''Note''': if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step"). If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated. | |
| − | |||
| − | If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated. | ||
| − | |||
| − | |||
Revision as of 08:30, 22 January 2021
Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer?
Possible encounters after upgrading CAN bus adapter:
- Vehicle doors Lock/Unlock is not working;
- Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "CAN-CONTROL cmd not supported".
If You endure with any of these issues - we offer a perfect solution.
Solution
After installation is complete and CAN bus adapter program is set, please, follow these steps:
- Do a learning procedure - using the vehicle key, unlock and lock vehicle three times;
- Send GPRS command - " lvcansetprog 11120" (or any other). Program number must contain 5 digits.
- Send GPRS command - " lvcansetprog the one that is for Your vehicle model". Program number can be seen in at the top of the CAN adapter connection scheme.
- After receiving a response to a command, repeat the learning procedure (first step).
Note: Before SMS text, two space symbols should be inserted if no SMS username or password was set in SMS / Call settings.
After completed these steps, commands to open/close and to block/unblock engine can be performed.
All SMS/GPRS responses should inform You that particular command has been completed successfully.
Note: if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step"). If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated.
