Difference between revisions of "FMB003 E-Mark"
m |
m |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[File:E24 logo.PNG|thumb|right|150px|]] | |
==Standards applied== | ==Standards applied== | ||
| Line 33: | Line 33: | ||
{{certification disclaimer}} | {{certification disclaimer}} | ||
| − | |||
| − | |||
{{emark links}} | {{emark links}} | ||
[[Category:FMB003 Certification & Approvals]] | [[Category:FMB003 Certification & Approvals]] | ||
Revision as of 18:11, 11 February 2021
Main Page > OBD Trackers > FMB003 > FMB003 Certification & Approvals > FMB003 E-Mark
Standards applied
This Approval shall apply to a type of electrical/electronic sub-assemblies (ESA) from serial production under the following conditions:
Individual products from serial production shall comply at least with all requirements set out in the Regulation No. 10. "Uniform provisions concerning the approval of vehicles with regard to electromagnetic compatibility".
Approval no.: E24*10R06/01*3427*00
The attached test report and drawings shall be a constituent part of this Approval.
Every product shall be marked with a readable and durable:
- approval marking.
This type of product shall be allotted the following approval marking:
Attachments
You can find the PDF version of the certificate here.
Disclaimer:
Test reports that are referenced in declarations and certificates can be provided upon request. For the request to be approved, the recipient of the test reports should be a certification authority or certified test house. The recipients will be asked to sign a non-disclosure agreement (NDA).
https://unece.org/fileadmin/DAM/trans/main/wp29/wp29regs/2019/E-ECE-324-Add.9-Rev.6.pdf
