Difference between revisions of "Test Dual Cam wiki"
From Wiki Knowledge Base | Teltonika GPS
MindaugasK (talk | contribs) |
|||
| (21 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Teltonika DualCam is connected to '''FMB125,FMC125 and FMB225, FMC225''' devices using the RS232 interface. <br> [[File:DualCam1.png|alt=|283x283px]]<br> | |
| − | + | __TOC__ | |
| − | |||
| − | |||
*[[First Start]] | *[[First Start]] | ||
*[[Camera Manual]] | *[[Camera Manual]] | ||
*[[DualCam Configuration]] | *[[DualCam Configuration]] | ||
| + | *[[DualCam Data Sending Parameters ID]] | ||
*[[Data image/video review]] | *[[Data image/video review]] | ||
| − | *[[DualCam | + | *[[DualCam Firmware errata]] |
| − | *[[DualCam | + | *[[DualCam comunication protocol]] |
*[[DualCam SMS commands]] | *[[DualCam SMS commands]] | ||
| − | *[[DualCam | + | *[[DualCam update procedure]] |
*[[DualCam Certifications & Approvals]] | *[[DualCam Certifications & Approvals]] | ||
*[[DualCam Troubleshoot]] | *[[DualCam Troubleshoot]] | ||
| − | + | ==Other camera related functionality== | |
| − | + | Camera is configured if all of these conditions are met: | |
| − | |||
| − | |||
| − | |||
| − | == | ||
| − | |||
| − | + | #'''RS232 mode is selected (DualCam)''' | |
| + | #'''Camera was not configured since startup or one of the related parameters were changed (compression, framerate or OSD)''' | ||
| + | #'''Camera file transfer is not active''' | ||
| − | + | Active camera reconfiguration is accompanied by two consecutive camera shutter clicks. | |
| + | If camera is disconnected and later reconnected, a device will detect it by periodic camera ping packet. Once camera is detected, the device will reissue the reconfiguration procedure. | ||
| + | <br> | ||
Revision as of 07:25, 15 July 2022
Teltonika DualCam is connected to FMB125,FMC125 and FMB225, FMC225 devices using the RS232 interface.
- First Start
- Camera Manual
- DualCam Configuration
- DualCam Data Sending Parameters ID
- Data image/video review
- DualCam Firmware errata
- DualCam comunication protocol
- DualCam SMS commands
- DualCam update procedure
- DualCam Certifications & Approvals
- DualCam Troubleshoot
Camera is configured if all of these conditions are met:
- RS232 mode is selected (DualCam)
- Camera was not configured since startup or one of the related parameters were changed (compression, framerate or OSD)
- Camera file transfer is not active
Active camera reconfiguration is accompanied by two consecutive camera shutter clicks.
If camera is disconnected and later reconnected, a device will detect it by periodic camera ping packet. Once camera is detected, the device will reissue the reconfiguration procedure.
