142
edits
Changes
mLine 44:
Line 44: − + Line 81:
Line 81: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
no edit summary
|}
|}
==NBL-2 updating==
==NBL-2 Configuration==
First, you have to make sure that NBL-2 firmware version is updated to 1.3.
First, you have to make sure that NBL-2 firmware version is updated to 1.3.
7. Correct firmware update will be signaled by device start-up led message.
7. Correct firmware update will be signaled by device start-up led message.
'''2. POWER OFF /RESET TO DEFAULT SETTINGS'''
To set factory defaults and un-pairingboth buttons must be pressed for 5 seconds additionally button 1 (blue) must be pressed first. It is also factory/transport configuration.
Procedure:
# Press Button1 and hold
# Press Button2 and hold
# Keep the buttons pressed for 5 seconds
# The return to the factory settings will be signaledby flashing LED1 and LED2
'''3. POWER ON (AFTER POWERED OFF)'''
Procedure:
1.Press Button 2 and hold
2.Keep the button pressed for 5 seconds
3.The PowerOnwillbe signaledby flashing LED1 and LED2
'''3. PARING'''
When device have defaults settings, reader waits for button then sends advertising packet for 50 seconds and blinks LEDs. First connection in this state is pairing process. Paring mode used: No Pin.
When the device is paired, the pairing mode is changed to pairing using the PIN. This prevents the pairing of additional devices
==Device configuration==
==Device configuration==
Setting up NBL-2 device to connect with FMB device. Go to Teltonika configurator -> Bluetooth 4.0 and set it up like it shown in this screenshot (MAC address will depend on your particular NBL sensor):
Setting up NBL-2 device to connect with FMB device. Go to Teltonika configurator -> Bluetooth 4.0 and set it up like it shown in this screenshot (MAC address will depend on your particular NBL sensor):
