Difference between revisions of "Manual CAN Commands"
From Wiki Knowledge Base | Teltonika GPS
| (37 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | { | + | |
| − | + | To use '''Manual CAN commands functionality''' user should select '''''Manual CAN Commands'' tab''' in '''Configurator'''. Afterwards, user will be able to configure CAN parameters in Manual CAN commands settings tab. | |
| + | |||
| + | ==Manual CAN Commands== | ||
| + | |||
| + | The main benefit of using '''Manual CAN command functionality''' is that the user is able to send data via CAN BUS without requiring additional CAN protocol development from the device's firmware side if vehicle should take an action with equipment connected via CAN line. To send command via CAN line with this functionality, the user must have: | ||
| + | |||
| + | * '''FMC650/FMM650/FMB641''' device | ||
| + | |||
| + | {| class="wikitable" style="border-style: solid; border-width: 0px;" | ||
| + | |+ | ||
| + | | style="width: auto; text-align: left; background: #F6F6FB;" |'''03.00.13.Rev.05''' or newer firmware (for FMC650/FMM650) | ||
| + | | style="width: auto; text-align: left; background: #F6F6FB;" |'''03.01.00.Rev.00''' or newer firmware for (FMB641/FMC650/FMM650) | ||
| + | |} | ||
| + | |||
| + | * Transport or equipment with CAN interface which works via ''J1939 protocol'' | ||
| + | |||
| + | * Transport or equipment CAN communication protocol (with information about ''frames'', ''parameters'', ''ID‘s'', ''Baudrate'') | ||
Revision as of 12:03, 29 August 2023
Main Page > Professional Trackers > FMC650 > FMC650 Configuration > Manual CAN CommandsTo use Manual CAN commands functionality user should select Manual CAN Commands tab in Configurator. Afterwards, user will be able to configure CAN parameters in Manual CAN commands settings tab.
Manual CAN Commands
The main benefit of using Manual CAN command functionality is that the user is able to send data via CAN BUS without requiring additional CAN protocol development from the device's firmware side if vehicle should take an action with equipment connected via CAN line. To send command via CAN line with this functionality, the user must have:
- FMC650/FMM650/FMB641 device
| 03.00.13.Rev.05 or newer firmware (for FMC650/FMM650) | 03.01.00.Rev.00 or newer firmware for (FMB641/FMC650/FMM650) |
- Transport or equipment with CAN interface which works via J1939 protocol
- Transport or equipment CAN communication protocol (with information about frames, parameters, ID‘s, Baudrate)
