Line 5: |
Line 5: |
| '''Description:''' | | '''Description:''' |
| | | |
− | Netronix NBL-3 - wireless Bluetooth RFID reader with additional buttons. | + | Netronix NBL-3 - wireless Bluetooth® RFID reader with additional buttons. |
| | | |
| '''NBL-3 is great in these use cases:''' | | '''NBL-3 is great in these use cases:''' |
Line 18: |
Line 18: |
| | | |
| * Mifare® Classic, Desfire card supports | | * Mifare® Classic, Desfire card supports |
− | * Bluetooth low energy module | + | * Bluetooth® low energy module |
| * Operating frequency - 13,56MHz | | * Operating frequency - 13,56MHz |
| * Built in two LED indicators | | * Built in two LED indicators |
Line 25: |
Line 25: |
| * UID and card DATA available | | * UID and card DATA available |
| * Configure via BL link | | * Configure via BL link |
− | * Firmware update via Bluetooth | + | * Firmware update via Bluetooth® |
| | | |
| ==Product Specification== | | ==Product Specification== |
Line 60: |
Line 60: |
| | | |
| ==Device configuration== | | ==Device configuration== |
− | NBL-3 support is available from firmware version '''03.29.00.Rev.230''' or newer. | + | NBL-3 support is available from firmware version '''03.29.00.Rev.233'''. |
| | | |
| Setting up NBL-3 device to connect with FMB device. | | Setting up NBL-3 device to connect with FMB device. |
| | | |
− | Go to Teltonika configurator -> Bluetooth 4.0 and set it up like it shown in this screenshot (MAC address will depend on your particular NBL sensor): | + | Go to Teltonika configurator -> Bluetooth® 4.0 and set it up like it shown in this screenshot (MAC address will depend on your particular NBL sensor): |
| | | |
| [[File:NBL3 11.png|frameless|660x660px]] | | [[File:NBL3 11.png|frameless|660x660px]] |
Line 114: |
Line 114: |
| | | |
| ==NBL-3 broadcasting behaviour== | | ==NBL-3 broadcasting behaviour== |
| + | |
| * When NBL-3 device captures RFID value it keeps broadcasting it for roughly a minute (it varies). NBL-3 manufacturer Netronix states that it is currently impossible to detect when the same RFID is attached to NBL-3 device again (when RFID value is still present after first read). New RFID read can only be indicated after NBL-3 value retention timeout is finished. When attaching different cards each time to reader, all will be read without issues. | | * When NBL-3 device captures RFID value it keeps broadcasting it for roughly a minute (it varies). NBL-3 manufacturer Netronix states that it is currently impossible to detect when the same RFID is attached to NBL-3 device again (when RFID value is still present after first read). New RFID read can only be indicated after NBL-3 value retention timeout is finished. When attaching different cards each time to reader, all will be read without issues. |
| <br> | | <br> |