301
edits
Changes
→ADAS configuration for FMx650
[[File:Adas conf2.png|center|frameless|1000x1000px]]
[[File:Adas conf2.png|center|frameless|1000x1000px]]
==ADAS configuration for FMx650==
'''(!) Required firmware version - 03.00.14.Rev.116'''. [[DSM_Firmware_errata|Firmware errata.]]
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
[[Image:Data_protocol.gif|300px]]
*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''ADAS''' in the Mode drop-down menu, afterwards '''ADAS COM1''' and '''Camera I/O''' should appear in the tab list.
[[Image:ADAS COM1.gif|600px]]
*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''
'''
[[File:ADAS CameraIO.gif|500px]]
'''
*In appeared ''ADAS COM1'' tab, make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''File upload settings''
[[File:ADAS.png|500px]]
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
===Connecting two cameras simultaneously for FMx650===
------------------
The new feature for FMx650 ADAS configuration, which is available from '''03.00.14.Rev.114-Rev.116 iCamera''' allows you to connect two of your cameras at once. Method for connection and configuration stays the same, for this you are only required to choose '''two''' cameras in '''"RS232 \ RS485"''' tab from the configurator.
In the new functionality, you are able to connect any combo of the cameras by your wish, as an example: you are able to connect ''ADAS/DSM'', ''ADAS/DualCam'', ''DSM/Dualcam'', ''DashCam/DualCam'', ''DSM/DSM'', ''DualCam/DualCam'' and etc.
[[File:Twincamera.gif|500px]]
==FMx125/FMX225 Configuration==
==FMx125/FMX225 Configuration==
==Crash Detection Functionality using DOUT==
==Crash Detection Functionality using DOUT==
'''The crash detection feature''' is a crucial capability provided by our device. It enhances evidential documentation through video or photo evidence in the event of a crash. However, '''activating this functionality necessitates a direct connection of the camera to a power source.''' Nonetheless, such a direct connection can lead to '''battery drainage'''.
'''The crash detection feature''' is a crucial capability provided by our device. It enhances evidential documentation through video or photo evidence in the event of a crash. However, activating this functionality necessitates a direct connection of the camera to a power source. Nonetheless, such a direct connection can lead to '''battery drainage'''.
To circumvent this issue, we recommend utilizing DOUT and a relay for connection. This setup enables control via SMS or GPRS command, or through predefined scenarios within our device. By activating DOUT post-ignition, the camera receives power, allowing it to function and record evidence even after the ignition is turned off following a crash. '''For your convenience, the connection scheme can be found here: [[ADAS First Start]]'''
To circumvent this issue, we recommend utilizing DOUT and a relay for connection. This setup enables control via SMS or GPRS command, or through predefined scenarios within our device. By activating DOUT post-ignition, the camera receives power, allowing it to function and record evidence even after the ignition is turned off following a crash. '''For your convenience, the connection scheme can be found here: [[ADAS First Start]]'''
