137
edits
Changes
→Battery settings
* '''GNSS''' - if GPS fix is acquired and speed >= 5 km/h vehicle then the MOVING mode is used; if GPS speed <5 km/h, the Vehicle on STOP mode is used;
* '''GNSS''' - if GPS fix is acquired and speed >= 5 km/h vehicle then the MOVING mode is used; if GPS speed <5 km/h, the Vehicle on STOP mode is used;
* '''Power voltage''' - Data acquisition > "moving" mode (Parameter state = 1) - when power voltage is >= low power voltage and <= high power voltage. By default low voltage is 13.2 V and the high voltage is 30 V;
* '''Power voltage''' - Data acquisition > "moving" mode (Parameter state = 1) - when power voltage is >= low power voltage and <= high power voltage. By default low voltage is 13.2 V and the high voltage is 30 V;
* '''DIN1''' - Data acquisition > "moving" mode (Parameter state = 1) - when voltage measured by DIN 1 is higher than 7.5V. Data acquisition > "on stop" mode (Parameter state = 0) - when voltage measured by DIN 1 is lower than 7.5V.
* '''DIN 1''' - Data acquisition > "moving" mode (Parameter state = 1) - when voltage measured by DIN 1 is higher than 7.5V. Data acquisition > "on stop" mode (Parameter state = 0) - when voltage measured by DIN 1 is lower than 7.5V.
<br>
<br>
<br>
<br>
<br />
<br />
==Movement delay==
==Movement delay==
[[File:FTC movement delay.png|right|500 px]]
[[File:Movement Delays.png|right|500 px]]
''Movement delay'' will be use to set timeout of delay when will be detected accelerometer status changes.<br></br>
''Movement delay'' will be used to set the timeout of delays when the accelerometer status changes.<br></br>
'''Note:''' these settings impact ignition/movement sources.<br>
'''Note:''' These settings impact the ignition/movement sources.<br>
The user can set:
The user can set:
* '''Motion start delay (s)''' - movement start delay in seconds;
* '''Movement start delay (s)''' - movement start delay in seconds;
* '''Motion stop delay (s)''' - movement stop delay in seconds;
* '''Movement stop delay (s)''' - movement stop delay in seconds;
<br />
<br />
<br />
<br />
'''On need'''—Battery will charge on need <br>
'''On need'''—Battery will charge on need <br>
'''After ignition ON'''—battery will be charged after the ignition source will be ON <br>
'''After ignition ON'''—Battery will start charging when the ignition source is turned ON <br>
'''Always'''—Battery will be charged all the time <br>
'''Always'''—Battery will charge all the time <br>