Changes

* '''Angle''' - this parameter defines the angle that needs to be exceeded for fall detection to start counting Alarm Delay. The zero point angle (ground vector) is updated every time the device goes from movement state 1 to 0. It is also updated just before going to sleep.

* '''Angle''' - this parameter defines the angle that needs to be exceeded for fall detection to start counting Alarm Delay. The zero point angle (zero vector) is updated every time the device goes from movement state 1 to 0. It is also updated just before going to sleep.

* '''Alarm Delay''' - this parameter sets time for how long the configured angle needs to be exceeded for the alarm event to trigger. The angle is checked every 1 second, so if during the alarm delay time the device is put back into vertical position (device angle is less than configured detection angle) the alarm delay resets.

* '''Alarm Delay''' - this parameter sets time for how long the configured angle needs to be exceeded for the alarm event to trigger. The angle is checked every 1 second, so if during the alarm delay time the device is put back into vertical position (device angle is less than configured detection angle) the alarm delay resets.

* '''Active Time''' - amount of time that has to pass after movement goes from 1 to 0, before vector gets sstored and angle starts being checked.

* '''Active Time''' - amount of time that has to pass after movement goes from 1 to 0, before vector gets sstored and angle starts being checked.