Difference between revisions of "FMB202 Installation instruction"
(Created page with "FMB2YX is the device that has internal GNSS and GSM antenna. Internal GNSS antenna device should be mounted with the sticker view to the open sky (metal free) with not less th...") |
|||
| (13 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{ | |
| − | + | Template:FMB2_Installation_instruction | |
| − | + | |model=FMB202 | |
| − | + | }} | |
| − | + | [[Category:FMB202 Manual|2]] | |
Latest revision as of 15:26, 7 December 2021
Main Page > Advanced Trackers > FMB202 > FMB202 Manual > FMB202 Installation instructionPossible mounting zones
Trucks
It is strongly recommended to mount FMB202 outside of the vehicle with the sticker direction to the sky.
Most commercial trucks have plastic hood in front of the vehicle. It is recommended to mount FMB202 under the hood. Power cord output of the device should be at the bottom. If it is not possible, if a front hood is made of some kind of metal, the device can be mounted inside the car on the front panel as close as possible to the front window.
Tractors
It is strongly recommended to mount FMB202 outside of the vehicle with the sticker direction to the sky.
Motor bikes
FMB202 device should be mounted on outside.
FMB202 cannot be mounted under the seat!
Light vehicles
Most light vehicles has oblique front window that opens most part of interior front panel. FMB202 can be mounted under the plastic panel behind the front window, with the sticker
direction to a window (sky).
Recommended mounting positions
Best FMB202 mounting position is outside of vehicle with any metal above the device.
Recommended deviation from horizontal axis of vehicle max 3-5°.
Mounting position and recommended deviation from longitudinal axis of vehicle ±2°.
Restrictions
FMB202 device can not be mounted inside in the vehicle door!
FMB202 device cannot be mounted inside the vehicle!
Connecting power wires
- Device should be connected directly to battery. Power supply: 6V/12V/24V.
- If FMB202 is used in 6V system and power cables are extended.
Extension cable resistance should be less than 60 mΩ in sum of both, positive and negative, wires. 30 mΩ for single wire.
