Template:FMB2 Possible mounting zones: Difference between revisions
Simkunas.ma (talk | contribs) No edit summary |
Simkunas.ma (talk | contribs) No edit summary |
||
| Line 1: | Line 1: | ||
<font size="+3"><span style=color:#104996>'''Mounting recommendations'''</span></font> | <font size="+3"><span style=color:#104996>'''Mounting recommendations'''</span></font> | ||
==<font size="+2"><span style=color:#F49E21>Trucks</span></font>== | ==<font size="+2"><span style=color:#F49E21>Trucks</span></font>== | ||
It is strongly recommended to mount FMB2YX outside of the vehicle with the sticker direction to the sky [[Image:Trucks.png|800px|right]] | |||
</font> | </font> | ||
<font size="+2"><span style=color:#F49E21> 2. </span> Connecting power source. </font> | <font size="+2"><span style=color:#F49E21> 2. </span> Connecting power source. </font> | ||
Revision as of 13:18, 29 May 2018
Mounting recommendations
Trucks
It is strongly recommended to mount FMB2YX outside of the vehicle with the sticker direction to the sky
2. Connecting power source.
- Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on the car model, this may happen in 5 to 30 minutes period.
- When the module is connected, measure the voltage again to make sure it did not decrease.
- It is recommended to connect to the main power cable in the fuse box.
- 3 A, 125 V external fuse shall be used.
3. Connecting ignition wire.
- Be sure to check if it is a real ignition wire i. e. power does not disappear after starting the engine.
- Check if this is not an ACC wire (when key is in the first position, most of the vehicle electronics are available).
- Check if power is still available when you turn off any of vehicles devices.
- Ignition is connected to the ignition relay output. As alternative, any other relay, which has power output when ignition is on, may be chosen.
4. Connecting ground wire.
- Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.
- If the wire is fixed with the bolt, the loop must be connected to the end of the wire.
- For better contact scrub paint from the spot where loop is going to be connected.