Difference between revisions of "FM3001 Auto Geofence Settings"
| Line 1: | Line 1: | ||
| − | {{Template:FMB Auto Geofence settings|model=FM3001|pic_autogeofence=[[Image:Fmb001 autogeofence.png|300px|right]]}} | + | {{Template:FMB Auto Geofence settings|model=FM3001|pic_autogeofence=[[Image:Fmb001 autogeofence.png|300px|right]]|text_din= |
| + | *Ignition input - If ignition input is detected. | ||
| + | *iButton – If authorized iButton is attached. | ||
| + | *Power Voltage – If power voltage becomes higher than low voltage level (defined in Ignition settings). | ||
| + | *Engine RPM – If engine RPM value becomes higher than 0.}} | ||
Revision as of 12:27, 30 May 2018
Main Page > EOL Products > FM3001 > FM3001 Configuration > FM3001 Auto Geofence Settings
AutoGeofence is based on the last known position after the movement has stopped. You can be notified using this function if your car is taken away. The shape and size of Geofence zones are set by parameters. It is possible to state whether entering or leaving the geofence triggers an asynchronous message.
AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure:
Activation timeout defines the delay between the creation of AutoGeofence within set Radius value around vehicle's most recent position and when the ignition is off. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility. Event generation can take place on Geofence Entrance, Exit or On Both. Eventual Records is used to enable or disable Eventual Records functionality. AutoGeofence can be deactivated by:
- Ignition input - If ignition input is detected.
- iButton – If authorized iButton is attached.
- Power Voltage – If power voltage becomes higher than low voltage level (defined in Ignition settings).
- Engine RPM – If engine RPM value becomes higher than 0.
