Difference between revisions of "FM6320 External Devices"
From Wiki Knowledge Base | Teltonika GPS
(Created page with "External Devices do not depend on selected profile; they are common for all profiles. To configure these parameters choose the TAB named “External Devices” and make all ne...") |
|||
| Line 2: | Line 2: | ||
[[Image:FMB630_external_devices.png|none|650px]] | [[Image:FMB630_external_devices.png|none|650px]] | ||
| − | + | [[Category:FM6320 Advanced Configuration]] | |
{| class="wikitable" | {| class="wikitable" | ||
|+ | |+ | ||
Revision as of 13:54, 30 April 2019
Main Page > EOL Products > FM6320 > FM6320 Configuration > FM6320 External DevicesExternal Devices do not depend on selected profile; they are common for all profiles. To configure these parameters choose the TAB named “External Devices” and make all necessary changes.
| Parameter Name | Parameter description |
|---|---|
| FMS/Tachograph Settings | Are used to configure CAN line and Tachograph setting such as Enable/Disable, baudrate, operation mode, tachograph ignition source, tachograph type. |
| Tacho Web | User can enable Web DDD synchronization functionality; enter tacho web server domain and port.User can enable Web DDD synchronization functionality; enter tacho web server domain and port. |
| Tacho Web start delay | When ignition is on Tacho web starts after this delay. |
| Analog Input Settings | User can change the range of analog inputs. There are two possible changes: 10 V (0-10 V) and 30 V (0-30 V). |
| COM1 and COM2 Settings | Configures COM1 and COM2 ports. User can configure baudrate, working mode, enable/disable timestamp and change CMD ID(used to identify from which COM port data came) |
| COM start/end byte | COM1 and COM2 start and end byte are filter for TCP Binary link mode. |
| RS485 Settings(COM1) | Configures RS485 settings such as activation of RS485 protocol, baudrate and working mode. |
| LLS Sensor Settings | Allows user to set LLS sensors addresses in preffered order |
