Difference between revisions of "FMB962 LED status"
From Wiki Knowledge Base | Teltonika GPS
(Created page with "{{Template:FMB1 LED status|model=FMB962}}") |
|||
| Line 1: | Line 1: | ||
{{Template:FMB1 LED status|model=FMB962}} | {{Template:FMB1 LED status|model=FMB962}} | ||
| + | [[Category:FMB962 Manual]] | ||
Revision as of 06:57, 6 May 2019
Main Page > EOL Products > FMB962 > FMB962 Manual > FMB962 LED statusThis section is an explanation of LED indications on an FMB962 device.
| Behaviour | Meaning |
|---|---|
| Permanently switched on | GNSS signal is not received |
| Blinking every second | Normal mode, GNSS is working |
| Off | GNSS is turned off because: Device is not working or Device is in sleep mode |
| Blinking fast constantly | Device firmware is being flashed |
Status LED Indications
| Behaviour | Meaning |
|---|---|
| Blinking every second | Normal mode |
| Blinking every two seconds | Sleep mode |
| Blinking fast for a short time | Modem activity |
| Off | Device is not working or Device is in boot mode |
CAN Status LED indications
| Behaviour | Meaning |
|---|---|
| Blinking fast constantly | Reading CAN data from vehicle |
| Permanently switched on | CAN unit unresponsive |
| Off | Wrong program number or wrong wire connection or CAN processor is in sleep mode = CAN data not received |
