Template:FMB9 First start card: Difference between revisions

Revision as of 14:29, 2 May 2019

Small and smart tracker with Blue-tooth

How to insert Micro-SIM card

Insert Micro-SIM card as shown with PIN request disabled or

read our Wiki how to enter PIN later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.

Connect battery as shown to device.
Connect micro usb cable as shown
To power up TST100, connect green plug to the E-scooter
Open Teltonika configurator, select TST100 device and

configure it according to your requirements (how to install drives on page

Once all done, disconnect TST100 from PC and E-scooter. Attach

the lid by two screws as shown

Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it.

How to insert microSD card

Push microSD card lock case.
Open microSD card locker.
Correctly insert microSD card into slot.
Close microSD card locker.
Push microSD card lock case to locked position.

NOTE: SD cards are only used in devices manufactured until 2018-04. Newer devices have internal flash memory.

@@ Line 11: / Line 11: @@
 =='''How to insert Micro-SIM card'''==
-# Gently remove {{{model|FMB9YX}}} '''cover''' using '''plastic pry tool''' from both sides.
+*Insert Micro-SIM card as shown with PIN request disabled or
-# Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read {{{sim_pin|[[FMB900 Security info|'''Security info''']]}}} how to enter it later in Configurator. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot.
+read our Wiki how to enter PIN later in Teltonika
-# Attach device '''cover''' back.
+Configurator. Make sure that Micro-SIM card cut-off corner is
-# Device is ready to be connected.
+pointing forward to slot.
+*Connect battery as shown to device.
+*Connect micro usb cable as shown
+*To power up TST100, connect green plug to the E-scooter
+*Open Teltonika configurator, select TST100 device and
+configure it according to your requirements (how to install
+drives on page
+*Once all done, disconnect TST100 from PC and E-scooter. Attach
+the lid by two screws as shown
 [[Image:Fmb920_cover_1.png|280px]][[Image:Fmb920_cover_2.png|280px]][[Image:Fmb920_cover_3.png|280px]][[Image:Fmb920_cover_4.png|280px]]