Difference between revisions of "Template:FMB9 First start card"

From Wiki Knowledge Base | Teltonika GPS
(Undo revision 34139 by Mariusandruska (talk))
(Undo revision 33686 by Mariusandruska (talk))
Line 11: Line 11:
 
=='''How to insert Micro-SIM card'''==
 
=='''How to insert Micro-SIM card'''==
  
*Insert Micro-SIM card as shown with PIN request disabled or
+
# Gently remove {{{model|FMB9YX}}} '''cover''' using '''plastic pry tool''' from both sides.
read our Wiki how to enter PIN later in Teltonika
+
# Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read {{{sim_pin|[[FMB900 Security info|'''Security info''']]}}} how to enter it later in Configurator. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot.
Configurator. Make sure that Micro-SIM card cut-off corner is
+
# Attach device '''cover''' back.
pointing forward to slot.
+
# Device is ready to be connected.
*Connect battery as shown to device.
 
*Connect micro usb cable as shown
 
*To power up TST100, connect green plug to the E-scooter
 
*Open Teltonika configurator, select TST100 device and
 
configure it according to your requirements (how to install
 
drives on page
 
*Once all done, disconnect TST100 from PC and E-scooter. Attach
 
the lid by two screws as shown
 
  
 
[[Image:Fmb920_cover_1.png|280px]][[Image:Fmb920_cover_2.png|280px]][[Image:Fmb920_cover_3.png|280px]][[Image:Fmb920_cover_4.png|280px]]
 
[[Image:Fmb920_cover_1.png|280px]][[Image:Fmb920_cover_2.png|280px]][[Image:Fmb920_cover_3.png|280px]][[Image:Fmb920_cover_4.png|280px]]

Revision as of 07:54, 7 May 2019

Qsg rut950 teltonika.PNG

Small and smart tracker with Blue-tooth

Fmb920 main.png




How to insert Micro-SIM card

  1. Gently remove FMB9YX cover using plastic pry tool from both sides.
  2. Insert Micro-SIM card as shown with PIN request disabled or read Security info how to enter it later in Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot.
  3. Attach device cover back.
  4. Device is ready to be connected.

Fmb920 cover 1.pngFmb920 cover 2.pngFmb920 cover 3.pngFmb920 cover 4.png


Alert.png
Micro-SIM card insertion/removal must be performed when device is powered off – external voltage and internal battery disconnected. Otherwise Micro-SIM card might be damaged or device will not detect it.

How to insert microSD card

  1. Push microSD card lock case.
  2. Open microSD card locker.
  3. Correctly insert microSD card into slot.
  4. Close microSD card locker.
  5. Push microSD card lock case to locked position.

NOTE: SD cards are only used in devices manufactured until 2018-04. Newer devices have internal flash memory.

Sd card 1.png Sd card 2.png Sd card 3.png Sd card 4.png Sd card 5.png